What do I need for an oil change on a Kia Sedona?
The tools needed to complete this oil change procedure include a 17mm socket with a 3/8″ drive ratchet, a 27mm socket with a 1″ drive ratchet, a floor jack, two jack stands, a used oil catch container, an automotive funnel and 6.02 U.S. quarts of new SAE 5W-30 oil.
How do I change the spark plugs on my Kia Sedona?
Disconnect the ignition coil connector (A). Once you have these off, then use spark plug socket, extension and ratchet to remove the spark plugs. Ok, you will have to remove the upper intake manifold (Kia refers to it as the surge tank). without doing this, you will not be able to access the plugs underneath it.
How to tighten the filter cap on a Kia Sedona?
Tighten the filter cap to just barely past finger tight with the 27mm socket or a 1 1/16″ wrench. The shop manual specifies that the filter cap should be tightened to 25.8 lb-ft of torque (35 Nm). Double check that the filter cap is tight. Line up the plastic engine cover and push it down into place.
How big is the oil drain bolt on a Kia Sedona?
Tighten the oil drain bolt with the 17mm socket and a 3/8″ drive ratchet to just past hand tight. If you have a torque wrench, the service manual specifies that the oil drain bolt torque specification is 26 to 33 lb-ft (35-45 Nm).
The tools needed to complete this oil change procedure include a 17mm socket with a 3/8″ drive ratchet, a 27mm socket with a 1″ drive ratchet, a floor jack, two jack stands, a used oil catch container, an automotive funnel and 6.02 U.S. quarts of new SAE 5W-30 oil.
Disconnect the ignition coil connector (A). Once you have these off, then use spark plug socket, extension and ratchet to remove the spark plugs. Ok, you will have to remove the upper intake manifold (Kia refers to it as the surge tank). without doing this, you will not be able to access the plugs underneath it.
Where is the oil filter cap on a Kia Sedona?
The engine cover is held in place by four rubber friction fasteners attached to metal pegs on the top of the engine. Locate the round black plastic oil filter cap at the right (driver) side of the engine. To remove the oil filter cap, you’ll need either a 27mm or a 1 1/16″ wrench or socket.
Tighten the oil drain bolt with the 17mm socket and a 3/8″ drive ratchet to just past hand tight. If you have a torque wrench, the service manual specifies that the oil drain bolt torque specification is 26 to 33 lb-ft (35-45 Nm).