What causes the light to turn off on a Titan?
If you want the light to turn off remove the modification in the drive. A regularly maintained FDD’s will rarely cause any problems. The majority of problems that do occur on a FDD can be fixed easily. The most common problem occurs when the 34 way ribbon cable is removed from the FDD.
What should I do if my Titan tablet is not working?
When the Power LED is on and the LED does not flash when the stylus is on the working area, then check and make sure all the connections are secure. If the breakdown is due to disconnection, switch off the desk and connect all the cables firmly and then restart the desk and the graphics tablet.
What causes the spindle motor on a Titan to burn out?
The most common problem occurs when the 34 way ribbon cable is removed from the FDD. Remove the cable from the back of the FDD and re-insert it correctly. Spindle Motor or Electrical Circuit Burn Out – With age, the spindle motor and electrical circuits can burn out, but this doesn’t happen very often.
What should firmware update date be on Titan?
10) The update process should happen automatically and will take about 10min.. To verify that the firmware has updated successfully you can select the Dmx Panel (int USB Expert) and in the Info tab it should display the SoftwareVersion. This should read “Nov 6 2014”. FAQ 10033 – An error has been detected which is preventing start up.
Why does my car only run forward or reverse?
If your vehicle won’t run or only runs slow or only goes forward or reverse. These switches could be the problem.If you have a vehicle that only goes forward or reverse or high low. Under the switches you will see the wires connecting to each switch.
Why is my CVT dying on my Nissan club?
Part of your cvt dying. Whining would be next after the tranny warms up. Just had mine replaced at 175km. Took the tech out for a spin after it was warmed up and within a block, he said the belts were slipping causing the noise.
Why does my Altima not move when I press the gas pedal?
Altima QR too. Good question…..if the motor was not revving up and the car won´t move, seems the TPS at the acc pedal assembly, is faulty..but the SES light should be on. This experience was with a friend’s car of mine…