What causes no spark to ignition coil?
Misfiring can be caused by loss of spark; imbalanced air/fuel mixture; or loss of compression. Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap.
Why are my spark plugs not sparking?
If you do not see a spark, there is an ignition problem. No spark indicates an ignition problem. If an engine has a coil-on-plug ignition system with no plug wires, remove one of the coils from the spark plug and insert an old spark plug, a spark plug tester or a screwdriver into the end of the coil.
What to do if there is no spark at the ignition coil?
Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds. If there’s spark, the problem is with the distributor cap or rotor.
How can you tell if ignition control module is good?
Because the clearest indication that the ignition control module and the crankshaft position sensor are good is if there’s spark coming from all of the spark plug wires. So if you haven’t checked, stop now and do a spark test on all of the spark plug wires.
Why is there no spark at the coil axle?
If there’s no voltage, check the wire between the ignition switch and the coil and, if necessary, the switch itself. If there’s voltage, the problem may be with the pickup unit. If the pickup is good, then the problem may be with the ignition control module.
What to do when your engine has no spark?
If there’s no spark or the spark is weak, check the resistance of the wire that connects the ignition coil to the distributor cap. Consult the wire resistance specifications in your repair manual.
Why is there no spark from the ignition coil?
Its like the ignition coil is not collapsing to send the spark energy to the spark plugs. How can you check the pickup coil to see if the timing events are happening in order to make and break the ground on the ignition coil in order to induce a spark on the secondary side, so that spark energy is sent to the spark plugs?
What does no spark no start condition mean?
Check that power is reaching the coil packs or ignition coil-on-plug coils. If power is not reaching any of the coil-on-plugs or ignition coil packs, you’ll get a bona-fide ‘no spark no start condition’.
What should I look for when cranking ignition coil?
Crank Engine and check for ICM switching at ignition coil while cranking. As ICM switches, primary voltage spikes can be seen. 25k ohms total resistance per wire. Distributor, coil, and igniter terminals.
Why did my car not start when I cranked the ignition?
The car did not start. That led me to suspecting something on the ignition side was wrong. I then removed the secondary coil wire going to the distributor cap and held it close to the strut tower to try and “see” a blue spark, as my dad was “cranking” the car.