What causes a p1516 code?
Possible Causes Open or shorted TAC module harness. Poor electrical connection in TAC module circuit. Water in TAC module connector. Binding or bent throttle-failed body.
Why is my Chevy Silverado throwing a u0107 code?
My single cab Chevy silverado is throwing a U0107 code causing the truck to have A message of reduced engine power. Along with that code I have 3 others, P1125 P1516 P2108. So far I have replaced and tried a tac module, computer, throttle body, throttlebody connector, gas pedal sensor and wiring.
How much does it cost to repair a GMC u0107?
The cost of diagnosing the U0107 GMC code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
When to use the diagnostic trouble code u0107?
The Diagnostic Trouble Code (DTC) U0107 is set when the Powertrain Control Module detects a loss of data or invalid data from the Throttle Actuator Control. Need more information on how to fix the U0107 GMC code?
What was the problem with the silveradosierra u0109?
Hard cranking, no start condition, etc. After a few months of the intermittent issue I finally got it to throw a code and it was the U0109 – “Lost Communication With Fuel Pump Control Module” I know there is a TSB on it to check connections on the passenger side of the trans as well as the actual FSCM module above the spare tire.
When is the u0107 GMC code detected?
When is the U0107 GMC code detected? The U0107 code is set when the Powertrain Control Module (PCM) detects a loss of data or invalid data from the Throttle Actuator Control (TAC) U0107 GMC Possible Symptoms Engine Light ON (or Service Engine Soon Warning Light) No throttle response U0107 Gmc Description
What are the symptoms of an u0107 engine code?
Symptoms of a U0107 engine code may include: Electronic Throttle Control Indicator On or Flashing No throttle response – engine will only idle Typically the causes for this code to set are:
What does the code u0107 stand for?
Code U0107 stands for Lost Communication with Throttle Actuator (TAC) Module. Older vehicles use a mechanical throttle linkage to connect the gas pedal to the throttle. Modern vehicles, however, do not have a throttle linkage.
Why is my gpcm not communicating with u0107?
If you can access codes from the TAC module, then the U0107 code is either intermittent or a memory code. If unable to communicate with the GPCM module, then the U0107 code that the other modules are setting is active, and the problem is there now. The most common failure is loss of power or ground.