What causes a fuel pump ignition switch to fail?
If the switch fails during heavy accessory loads, the internal contacts may have become heavily oxidized. In any case, most switches give ample warning of an impending failure under various conditions of temperature and load. Fault in the fuel pump circuit
What are the signs of a failing ignition switch?
Common Signs of a Failing Ignition Switch Engine Will Not Start. The problem here is probably: An anti-theft fault; Fault in the fuel pump circuit; Ignition circuit; Engine computer; If the anti-theft light is flashing, the computer is NOT recognizing the key or key fob and is; preventing the engine from starting.
What does no start, no fuel pump mean?
Not sure if that is the problem though as that fuse may get power after a relay closes? fuse is good. Any other ideas? No start, no spark, no fuel pump. working on my 2008 screaming eagle ultra classic that I just got. Engine is a no start.
Do you need a relay for a fuel pump?
Well from the looks of things they don’t use a relay with it as the switch seems to be capable of directly controlling fuel pump, but unclear how much current it can handle reliably. Another potential problem is you will need to route thicker wires from your battery (which may be in the rear) to the switch and then back to the pump.
Not sure if that is the problem though as that fuse may get power after a relay closes? fuse is good. Any other ideas? No start, no spark, no fuel pump. working on my 2008 screaming eagle ultra classic that I just got. Engine is a no start.
Why does my fuel pump not prime when I turn it on?
Pulled fuel pump relay and put in a jumper wire to run the fuel pump and it started. Put the fuel pump relay back in and it starts and drives, but the fuel pump still doesn’t prime when turning the key on. I’m afraid that after sitting overnight, it will once again refuse to start.
Why is the fuel pump relay not closing?
If jumping the fuel pump relay makes the pump run, and if the relay tests good. Then you need to determine why the ECM is not telling the relay to close. Start by testing continuity back to the ECM. Here is the electrical diagram for the 01 Tib Fuel Pump Relay
How can I get my fuel pump to run?
Swap an accessory fuse wuth the ignition fuse and give it a whirl. also if I use a “power probe” and apply battery voltage to the fuel pump fuse the fuel pump does run. thanks nipplesurfer, I did try that yesterday.