What causes a Chevy S10 to start sputtering?
Normally it idles around 950-1050 RPM, what has been happening is that it would start, idle high, around 1500, then drop to normal, and then start sputtering and RPMs would fluctuate anywhere between 750 on the high side, all the way to 0, stalling the motor.
What makes the engine sputter at 3000 rpm?
The fuel cuts out and starts to sputter at 2000 rpm all the way to 3000 rpm. I have changed plugs, MAP, TPS, IAT, crank sensors, wires, cool pack, cool mod, fuel pressure, fuel pump, crank, timing gears and chain ECM/ECU. Checked grounds, injectors, head gasket. I check compression it is 180 across the board.
Is the engine idles fine but no power on acceleration?
This is for a 1995 chevy s10, 2.2L four cyclinder, automatic and regular body style with approximately 170 K miles. After every long trip I have to top off the engine oil. Now, I smell burnt oil and it loses power when driving and also idles rough. Also, on your conclusion, what would be a estimate ( by average ) for repairs. helpful?
Why does my Sonoma S15 stall and die?
I have a 98 sonoma ( 4 cyl.) that runs great and strong going down the road but when I stop and start to take off it bogs down and dies, It will start back up in 5 to 10 mins. and will run good for several days and then it will die again . I have been told that it is the 3rd cycl.
Normally it idles around 950-1050 RPM, what has been happening is that it would start, idle high, around 1500, then drop to normal, and then start sputtering and RPMs would fluctuate anywhere between 750 on the high side, all the way to 0, stalling the motor.
What does sputter, idle, hesitation under load mean?
Well, I have been having the same problems that many of us on here are having with an iradic idle, hesitation under load, and sputtering up to like 3000 rpm. My idle was so bad it started dieing on its own.
Why does my Briggs and Stratton lawn mower keep sputtering?
So I’ve got a Bolen by MTD with a Briggs and Stratton 550 engine. It has started sputtering while I’m cutting grass. It acts as though it’s about to die, then revs back up, then revs down, then up.
How is my 1994 S-10 4.3 running?
Starts fine, even today when it was -15, fuel pressure 52 running, holds after shut down, newer plugs/wires/cap rotor, tested MAP sensor and tests good, tested resistance changes in TPS (with sensor out) and changes were smooth along range, unplugged every sensor I could find individually looking for changes, no luck.