What can I do about intermittent shift to Park?
To reduce the inrush of current that causes the excessive build-up on the contacts, install an in-line shifter wiring harness jumper (Fig. 33) between the shifter base connector and the console harness connector. With the vehicle in Park and the ignition off, remove the transmission control (shifter) lever knob and boot assembly. (Fig. 34)
Why do I get a shift to Park message?
The Shift to Park message may be the result of a build-up of material on the contacts of the Park switch when it is activated in the transmission control (shifter) assembly.
Where to install the in line shifter jumper?
Install the in-line shifter wiring harness jumper between the shifter base connector and the console harness connector. The jumper harness should not be twisted or kinked in a 90 degree position. (Fig.
Why is my car transmission not in Park?
The excessive material may cause a higher than expected resistance in the signal circuit to the Body Control Module (BCM), and not allow the BCM to electronically see that the vehicle is in Park, even though the vehicle transmission is in the Park position.
Can a car not shift from Park to drive?
received a Car does not shift from park to drive Inspection. You start the car up, put your foot the brake, push the button on the shifter and it won’t shift out of park. What do you do now? Don’t force the shifter. Forcing the shifter out of park may cause more damage.
Why does my shift shifter not move through gears?
I’d suggest checking the shift linkage on the transmission to see if the cable came off. This is due to the connector end bushing falling apart and not being able to hold the cable on any longer. Some cables have to be replaced as a whole and as with others the bushing can be replaced to fix the cable.
The Shift to Park message may be the result of a build-up of material on the contacts of the Park switch when it is activated in the transmission control (shifter) assembly.
To reduce the inrush of current that causes the excessive build-up on the contacts, install an in-line shifter wiring harness jumper (Fig. 33) between the shifter base connector and the console harness connector. With the vehicle in Park and the ignition off, remove the transmission control (shifter) lever knob and boot assembly. (Fig. 34)