What are the possible causes of a Nissan p1283?
P1283 NISSAN Possible Causes. Faulty Air Fuel Ratio (A/F) Sensor 1 Bank 2. Air Fuel Ratio (A/F) Sensor 1 Bank 2 harness is open or shorted. Air Fuel Ratio (A/F) Sensor 1 Bank 2 circuit poor electrical connection. Low fuel pressure. Faulty Fuel injector. Intake air leaks.
What does Service Bulletin OBDII code p1283 mean?
Nissan Service Bulletin OBDII Code P1283 There is a factory service bulletin for the following Nissan models: 2004 Maxima (A34) with 5 speed A/T only 2004 Quest (V42) with 5 speed A/T only Nissan Factory Service Bulletin OBDII Code P1283 2004 Maxima (A34) with 4-speed A/T and 6-speed M/T 2004 Quest (V42) with 4-speed A/T
What happens when the O2 sensor is replaced?
If the mechanic completed the O2 sensor replacement, reset the codes and the error code was triggered again, it is possible that the catalytic converter is damaged and needs to be replaced.
What should I do if my oxygen sensor fails?
Always follow the instructions in your owner’s manual for Oxygen (O2) Sensor replacement. The Oxygen (O2) Sensor is a wear item and does fail over time. This will reduce the level of emissions your vehicle puts into the atmosphere. And, At the same time keep your engine running smoothly.
What are the problems with a Nissan Maxima 3.5?
IN THIS VIDEO I AM REPLACING TIMING CHAINS, TIMING TENSIONERS, TENSIONER SHOES, CHAIN GUIDES AND A WATER PUMP ON A 2004 NISSAN MAXIMA 3.5 WITH A NOISY TIMING CHAIN AND A COOLANT LEAK FROM A FAILED WATER PUMP. ALSO APPLIES TO ALTIMA WITH 3.5 V6. THANKS FOR WATCHING! PLEASE LIKE AND SUBSCRIBE FOR MORE “HOW TO” AND “INFORMATIONAL” VIDEOS! Loading…
Is there a problem with my Nissan Altima 3.5 SE?
I have a problem with my ’02 Nissan altima 3.5 SE that carries a chainsaw kind of noise coming from the engine. car is running fine and smoothly however there is this chainsaw noise from my engine when going at 2-3 rpm then its gone.