What are the main parts of a power puller?
Basic components of most power-pulling tools include frame, power source, the capstan that pulls the pulling rope and wire, and the mechanism that turns the capstan and pulling rope.
How to use a dent puller on a car?
How To Use Dent Pullers 1 Glue Puller. Attach the tab to the dent but don’t press too hard, the glue tab should be touching only the glue, not the panel. 2 Suction Puller. Use a little bit of water to moisten the suction surface. 3 Slide Hammer Puller. …
When do you need a special puller for a car?
When working on a car, you often come across specialty components that require specialty tools to remove and install them. One of the most common parts you may face are pulleys and gears. A lot of these are pressed on by the factory, and the only way to get them apart is with a specialty puller.
What kind of pullers should I have in my garage?
You can use them to remove gears, pulleys, wheel hubs, all kinds of hard to remove parts. They come in several sizes and are inexpensive. Every garage should have three sizes of 3-jaw pullers in the drawer. Just like the tie rod tools, the center stud is threaded to do the hard work for you.
What kind of Puller do you use to remove gears?
3-jaw – The most universal of pullers, the 3-jaw puller has three articulating arms that have both internal and external hooks. You can use them to remove gears, pulleys, wheel hubs, all kinds of hard to remove parts. They come in several sizes and are inexpensive.
Which is the best type of puller to use?
Removing a Gear, Bearing, Pulley, or Other Component from a Shaft Pulling a Shaft Out of a Housing or Bore Removing a Bearing or Bushing from a Blind Hole Tools to Use • Jaw Type Puller 2 or 3-jaw style, with 3-jaw being the best choice. Manual or hydraulic with outside jaw positions.
How do you use a 3 jaw puller?
Slip it over the joint,. thread the spindle to the stud and tighten until pops loose. 3-jaw – The most universal of pullers, the 3-jaw puller has three articulating arms that have both internal and external hooks. You can use them to remove gears, pulleys, wheel hubs, all kinds of hard to remove parts.
What kind of bullet puller do I Need?
The Grip-N-Pull bullet puller is a precision-machined hand clamp that works for multiple calibers. A single Grip-N-Pull can replace several other tools, while being faster to use. With larger-diameter bullets loaded with light-to-moderate neck tension, it works well. The bullets come out pretty easily, with no scuff marks or dents.
What should the inside diameter of a puller be?
The inside diameter should range between 1/4” and 7”. Pulling can be done with bridge, bar type yokes, or slide hammers. See page 358 for full information. • Bearing Adaptors with Slide Hammer Puller CJ127A, CJ128A, and CJ137 Bearing Adaptors with CJ97-3A Slide Hammer should be used in this application. • Bar Type Puller with Bearing Separator