What are causes of no spark from the ignition coil?
What are causes of no spark from the ignition coil. Have changed the ignition module, ignition coil, the pickup coil in the distributer, ignition switch and still no spark at from the coil. Submitted: 11 years ago. Category: Ford What year is this truck? Do you have power at the + side of the coil with the key on?
Why is there no spark at the coil axle?
If there’s no voltage, check the wire between the ignition switch and the coil and, if necessary, the switch itself. If there’s voltage, the problem may be with the pickup unit. If the pickup is good, then the problem may be with the ignition control module.
What are the symptoms of a bad ignition coil?
This may seem like a no brainer because the most obvious symptom of a bad ignition coil is a no start no spark condition, but here are a few other symptoms you’ll see along with no spark: None of the spark plugs will fire spark. The fuel pump will still work. The PCM will still activate the fuel injectors.
How can I test the spark at the coil?
Using an Adjustable Ignition Spark Tester Test the ignition coil positive and negative side. Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds.
What happens when there is no spark from the ignition coil?
1 Power. Two positions of the ignition switch provide power to the positive primary post of the ignition coil. 2 Signal. With no external signal to the coil negative primary post, voltage would travel through the ignition coil windings without inducing any secondary spark. 3 Flow. 4 Open Circuits.
Using an Adjustable Ignition Spark Tester Test the ignition coil positive and negative side. Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds.
What causes a car engine to have no spark?
If only one or a few cylinders have a weak or no spark, the problem is in the secondary side of the system. Check for worn or damaged spark plug wires, worn or faulty distributor cap.
What happens when you replace the coil wire on an engine?
You can replace the secondary coil wire on an engine that uses one with an equal length of vacuum hose and the engine will start and run. The powerful spark will travel down the hollow hose to the distributor cap, but the engine will stall under any load because of the weakened spark.