Is there a manual for replacing a Mercedes transmission?
PLEASE NOTE: This is NOT a manual on how to repair or adjust your transmission. This only covers the steps for removing and replacing an automatic transmission in your Mercedes. The job is time consuming due to the number of bolts and connections that have to be removed.
When did Mercedes Benz stop using automatic transmission?
The tips and cautions presented will help you avoid many of the pitfalls experienced by other Mercedes owners who have attempted this job on their own. This covers all Mercedes models with Automatic Transmission from 1968 to 1993.
How to fix a Mercedes-Benz automatic transmission fluid change?
The remedy is to have the codes cleared with a professional scanner. My Gf’s 2000 MB E320 had the plug soaked in oil, I replaced it and had my local european indy shop erase the codes for me charged- they charged me $45. problem solved ever since. Almost 6k miles later and still smooth shifting. Hope this helps. God Bless.
Why did I replace the conductor plate on my Mercedes?
Replaced the conductor plate because of a bad shift solenoid. Also replaced the plug on passenger side because I had the dreaded fluid leak all the way to the TCM under the hood on passenger. Cleaned that as well and no more fluid to date.
How do you replace transmission on Mercedes Benz?
Install the two 13 mm bolts. Slowly lower the transmission. Make sure that the two holes line up so that you will be able to bolt the two bolts that tie the transmission mount to the support bracket. Torque the two 13 mm bolts to approximately 25 ft lbs. Install the splash shield / undercarriage plastic cover.
How often do Mercedes Benz engine and transmission mounts fail?
The engine and transmission mounts are not part of regular maintenance, meaning that typically then don’t need to checked or replaced on a regular basis. With that said Mercedes-Benz engine and transmission mounts seem to fail between 80,000 and 120,000 miles.
Where is the transmission mount on a Mercedes Benz?
The transmission mount is located at the middle of the vehicle. You may not be able to see it if the car has an undercarriage plastic cover also known as splash shield. You will need to remove about 6 screws to remove the splash shield. Use a 8 mm socket to remove the bolts shown in the picture. Typically Mercedes-Benz have three splash shields.
What happens when you change the first gear in a Mercedes?
By 40 degrees it would fade away and run smooth, but the first gear shifts until the car is warmed. Now the buzz wont go away and continue even at 80 degrees, although it works great. The sound is like a turbo or an electric motor. Would you please advice on what to do?.
Do you need manual to remove auto transmission?
If you plan on removing your auto transmission anytime soon this is a must-have manual that will walk you through the steps of removal and replacement in an easy to understand format. The tips and cautions presented will help you avoid many of the pitfalls experienced by other Mercedes owners who have attempted this job on their own.
How do you remove a retainer from a transmission?
Step 17 – Using a pick or screwdriver, gently pry the retainer clip from the clutch hydraulic line at the bell housing, (Note: If an externally mounted secondary cylinder or cable is used, unbolt or unclip from the transmission).