Is there a hesitation when taking off from a stop?
Our 2009 Murano is experiencing a hesitation when taking off from a stop. The car will start to go as usual then hesitates for a second or 2 then will take off like normal again. It also sometimes displays a hesitation or bog when accelerating from say 30 mph to 40 or 50 mph. Any advice? Thanks! Kent Submitted:5 years ago. Category: Nissan
Why does my car hesitate when approaching a stop?
Delay in acceleration happens when the engine does not get enough power. It needs more power than driving at a constant speed when pulling away from a stop. That power comes from the systems that control the fuel and airflow supply. Any issue with these components will make the car hesitates when accelerating from stop.
What causes engine to hesitate at low rpm?
If any of the vacuum hoses around your engine become damaged or worn out, you could experience air leakage from them. Then you will experience engine hesitation which is most noticeable at low RPM. Repair or replace any hoses which are causing the leak.
What should I do if my car hesitates when I press the gas?
Here’s what you might discover—and what you can do to fix the problem: Dirty air filter. The Fix: Replace the air filter. The spark plugs may be dirty or worn. The Fix: Replace spark plugs. The ignition wires may be bad. The Fix: Inspect and replace ignition wires. Ignition system problems. The Fix: Check distributor cap or rotor.
When did I start to have hesitation on acceleration?
I first experienced hesitation on acceleration at low (10-15 mph) speeds on a slight incline when there was a little over 200 miles on the car. When I would press the accelerator lightly, there was no response as if the engine died.
Delay in acceleration happens when the engine does not get enough power. It needs more power than driving at a constant speed when pulling away from a stop. That power comes from the systems that control the fuel and airflow supply. Any issue with these components will make the car hesitates when accelerating from stop.
Why does my Honda Odyssey hesitate after rounding a curve?
At first, the hesitation happened after rounding a curve following a “rolling” stop. It has happened several times since then and now it even does it when driving straight on level roads. It is at the Honda dealer now for the third time and their mechanic stated it happened when he was driving it with instrumentation hooked to the data port.
What causes engine hesitation on a Dodge truck?
The engine hesitation on your Dodge may be created by problems in one or more components. In most cases, a bad throttle position sensor (TPS) fails to signal the engine computer about throttle operation. Other causes may be bad or worn out components in the ignition secondary system, causing the engine to accelerate poorly and even stall.
When does a Murano hesitate from a stop?
2009 Nissan Murano hesitates from a stop. Much worse at high 2009 Nissan Murano hesitates from a stop. Much worse at high altitude, 9000 feet and on an incline. 182,000 miles. Runs fine once above 2,000 … read more
Why does my car not take off after a dead stop?
Like the air filter and fuel pump, the fuel injector is also prone to accumulating dirt and sludge over time, which affects its capacity to supply the correct amount of fuel for the combustion. As a result, the engine fails to produce enough power to take off smoothly after a dead stop.
Here’s what you might discover—and what you can do to fix the problem: Dirty air filter. The Fix: Replace the air filter. The spark plugs may be dirty or worn. The Fix: Replace spark plugs. The ignition wires may be bad. The Fix: Inspect and replace ignition wires. Ignition system problems. The Fix: Check distributor cap or rotor.