Is the monopole antenna on a Ford truck broken?
We think the design looks terribly dated, and to make matters worse, the antennas have been known to get broken and bent following just a little abuse (such as a run through an automatic car wash). We’re not alone on this – in fact, the aftermarket has supplied a variety of stubbier antenna replacements for years now.
Can a malfunctioning antenna cause poor radio reception?
A malfunctioning antenna can also mean poor or no radio reception whatsoever, which has the power to negatively impact your experience behind the wheel, to say the least. Get the best antennae for cars and trucks at AutoZone and get both the look and sound you’ve been missing out on by dealing with a fast, easy repair.
What happens if the antenna on your car breaks?
A broken antenna on a car, truck or SUV is much more of a nuisance than just a tick against the vehicle’s overall appearance. A malfunctioning antenna can also mean poor or no radio reception whatsoever, which has the power to negatively impact your experience behind the wheel, to say the least.
Is there an antenna on a Ford truck?
The modern Ford trucks lineup is cutting edge in a variety of ways, with one glaring exception: the exterior antenna design.
Why is my power antenna not going up and down?
If your power radio antenna won’t go up and down anymore, the problem is either a burned-out motor or the geared cable inside the mast. Both are easy DIY fixes. You can do the entire repair in about two hours. The parts run about $25 for a new cable/mast, plus the cost of the special wrench.
How long does it take to fix a stuck power antenna?
Complete this simple fix in about 2 hours. Fix a stuck power antenna by replacing a burned out motor or bad cable/mast. You can do both in about 2 hours, and you’ll avoid the $50 – $100 dealer service fee. You need only one special tool, an antenna wrench. Tilt the bottom of the antenna away from the fender and pull the unit down and out.
How to fix a power antenna on a car?
Check an auto parts store for one or order the Steck No. STC21600 (about $18) from amazon.com. Unscrew the bezel (Photo 1) and remove the antenna retaining bolts. If your power antenna is mounted inside the front fender, remove the wheel-well liner by pulling out the plastic rivets and push-in retainers.