Is my Harley throttle by wire?
Look at your handlebars. If there are two cables running down the handlebars it is cabled. If it doesn’t have any cables on the right side, it’s throttle by wire.
Can a Harley Davidson stop the limp mode from happening?
Harley should stop the limp mode from happening on a bike. Throw an engine code is fine, but limp mode can get somebody killed. Without limp mode you could get the following..FULL ACCELERATION..when the computer sees there is a problem with the TPS.
Why is my throttle control on permanent limp mode?
Let the silicon dry before reconnecting the connector to the TPS, this prevents the silicon from POSSIBLY running to the pin, preventing pin to pin contact. (Silicon on the TPS pins is a very bad thing = permanent limp mode until you remove all silicon from the pins and TPS plug.)
When did my 2008 Harley Davidson roadglide do it?
My 2008 Roadglide did it on Hiway 89 on the way to Tahoe. I got it home and went to Sacramento Harley and bought a bag of the connectors that go into the connector that plugs into the throttle body. Replace every connector with the special crimping tool I borrowed from a friend. That was two years ago and it’s still running great.
What’s the problem with the throttle on a Harley Davidson?
The P1511 and P2101 involves the throttle actuator and i’m going to try the grease and see if codes come back, but the U1040 comes up being lose of ABS serial data so looking far any solutions. The problem is it’s running better than it ever has.Good luck with yours.
Harley should stop the limp mode from happening on a bike. Throw an engine code is fine, but limp mode can get somebody killed. Without limp mode you could get the following..FULL ACCELERATION..when the computer sees there is a problem with the TPS.
Let the silicon dry before reconnecting the connector to the TPS, this prevents the silicon from POSSIBLY running to the pin, preventing pin to pin contact. (Silicon on the TPS pins is a very bad thing = permanent limp mode until you remove all silicon from the pins and TPS plug.)
My 2008 Roadglide did it on Hiway 89 on the way to Tahoe. I got it home and went to Sacramento Harley and bought a bag of the connectors that go into the connector that plugs into the throttle body. Replace every connector with the special crimping tool I borrowed from a friend. That was two years ago and it’s still running great.
The P1511 and P2101 involves the throttle actuator and i’m going to try the grease and see if codes come back, but the U1040 comes up being lose of ABS serial data so looking far any solutions. The problem is it’s running better than it ever has.Good luck with yours.