Is it safe to jump start a Harley Davidson?
Unless you happen to break down in front of the Harley Dealer, your options are limited to jump starting or having your bike towed. In this article, we’ll describe how to safely jump start your bike from another bike or, although there’s some legend out there that says not to, even a car. The procedure is the same.
How long should you crank a jump starter?
Crank for no more than 2-3 seconds at a time. Portable jump starters are designed to deliver short bursts of maximum power, so cranking for a long time will likely burn out the battery pack inside the jump starter. Once the bike starts, remove the negative clip first followed by the positive clip.
How do you attach a jump starter to a bike?
Jump starter packs usually come with an assortment of attachments, but the most common ones are the familiar clips seen on traditional jumper cables. Connect the positive clip (red handle) to the positive terminal (labeled POS or +). Connect the negative clip (black handle) to a bare metal surface on the bike or the negative terminal.
Can you jump start a motorcycle from a car?
The good news is that with proper precautions, you can jump start a motorcycle battery from a car without damaging the bike and with little risk to the battery. Turn off both vehicles and make sure lights and other equipment is also turned off. Open the car hood and remove any protective caps over the battery terminals on both vehicles.
Can you kick start a Harley Davidson Sportster?
If you’ve ever tried to kick start a big twin like a Sportster, you can imagine how much energy it takes to turn the crank fast enough and long enough to get a reliable start. The battery doesn’t have to be completely dead before you will have trouble starting your bike.
Why is my starter on my Harley Davidson not working?
Harley Davidson Sportster Starter Relay Not Working. There are a few common Motorcycle Starter problems. We will go throw a few start problems. You push the start button and you only hearing a click from your bike, With that we will test and fix this problem. Battery, Fuse and Starter Relay, If you have Any question just ask.
Can a pigtail harness jump start a bike?
If your bike has a pigtail harness attached intended for connecting your battery charger, do not be tempted to use this as a means to jump start. The amount of current required to start the bike is much greater than the charging current.
Why is my Harley Davidson Sportster not starting?
Place your Sportster in second or third gear for the best results. A battery that can’t start your engine may no longer be recharging properly because of its age and current state of charge. The ground cables that connect the battery to your Sportster frame must also be undamaged and free of corrosion.
How do you jump start a Harley Davidson?
Once the bike has started, remove the jumper cables in the reverse order they were attached. Remove the negative cable from the frame or engine block of your bike, then remove the negative cable from the helper battery’s negative terminal, followed by removal from the positive terminal of the helper battery.
What should the current be on a Harley Davidson starter?
In addition to the starter current draw test, you can measure the voltage at the wire connected to the starter solenoid from the ignition switch. With the ignition in the on/run position and the button pressed, 12 volts should be present at this wire.
Where is the starter on a Harley Davidson 883 Sportster?
Connect your red probe to the solenoid positive wire. This is a fat 12 or 14 gauge wire on the cylindrical portion of the starter. Connect the black probe to a known good ground. 12v should be present in this wire at all times. Figure 3. The starter location on a 883 Sportster.