Is it OK to drive a car with a bad O2 sensor?
Can You Drive With A Bad Oxygen Sensor? Yes, you can drive with a bad oxygen sensor if you can still start your engine and feel little difficulty driving. But don’t leave it alone for over a couple of days, as it might cause safety problems and lead to the malfunction of other parts of your vehicle.
What does the code p0138 mean on the O2 sensor?
What the P0138 code means. P0138 is the OBD-II generic code indicating the O2 sensor for bank 1 sensor 2 fails to have a lower voltage output below 1.2 volts for more than 10 seconds indicating a lack of oxygen in the exhaust stream.
What does p0138 mean on a Jeep Wrangler?
Users have reported P0138 for the following makes: Jeep (especially on a Jeep Wrangler), Dodge, Toyota, Nissan, and Chevrolet. Code P0138 means that your powertrain control module (PCM) has detected that the voltage signal from the rear O2 sensor is too high. What is an Oxygen Sensor? All modern cars have at least two oxygen sensors.
Why are there two bank 1 codes on Honda Odyssey?
Also both codes stated “Bank 1 and Sensor 2. Why are there two different code numbers? P0136 is a temporary code whereas P0138 is a permanent code. They both indicate Secondary HO2S (Sensor 2) Circuit High Voltage. 1. Reset the PCM.
What does the code p0138 on a boxer engine mean?
Code P0138 is set when the downstream sensor sends too high of a voltage signal for an extended period of time. The bank one portion of the code indicates that the issue is on the side of the engine that houses the number one cylinder (only applies to engines with a ‘V’ or boxer configuration).
What the P0138 code means. P0138 is the OBD-II generic code indicating the O2 sensor for bank 1 sensor 2 fails to have a lower voltage output below 1.2 volts for more than 10 seconds indicating a lack of oxygen in the exhaust stream.
Users have reported P0138 for the following makes: Jeep (especially on a Jeep Wrangler), Dodge, Toyota, Nissan, and Chevrolet. Code P0138 means that your powertrain control module (PCM) has detected that the voltage signal from the rear O2 sensor is too high. What is an Oxygen Sensor? All modern cars have at least two oxygen sensors.
Also both codes stated “Bank 1 and Sensor 2. Why are there two different code numbers? P0136 is a temporary code whereas P0138 is a permanent code. They both indicate Secondary HO2S (Sensor 2) Circuit High Voltage. 1. Reset the PCM.
Code P0138 is set when the downstream sensor sends too high of a voltage signal for an extended period of time. The bank one portion of the code indicates that the issue is on the side of the engine that houses the number one cylinder (only applies to engines with a ‘V’ or boxer configuration).