Is it necessary to change the leads when changing spark plugs?
You don’t need to change your spark plug wires when you change your spark plugs but if you are taking it to a mechanic and he is charging you…..you may want to avoid the 2nd visit. It’s up to you and your situation.
What’s the best way to replace a spark plug?
Using a wire puller, twist the boot to break the seal from the plug and then pull off the old plug. Match the old wire length to the new wire. Buy an adjustable spark plug wire puller to make the job easier. Apply dielectric grease to both the plug and the coil/distributor end of each wire.
What to look for in a bad spark plug?
What to Look For. Be sure to first check spark plug wires for visual damage. Look for any signs of melting or cracking. The following situations call for immediate replacement of spark plug wires: Vibration damage – Constant wear and tear caused by engine vibration can loosen the electrical connection at the spark plug.
What happens when spark plugs start to wear out?
Worn spark plug wires and boots can start to leak voltage to nearby engine parts, causing arcing and creating performance problems. Replace them before that happens. Use your camera to record the route of each wire and spark plug.
Why do I need to replace my spark plug wire?
The following situations call for immediate replacement of spark plug wires: Vibration damage – Constant wear and tear caused by engine vibration can loosen the electrical connection at the spark plug. This causes an increase in the voltage required to fire the spark plug, which could damage the ignition coil as well as the spark plug wires.
What to Look For. Be sure to first check spark plug wires for visual damage. Look for any signs of melting or cracking. The following situations call for immediate replacement of spark plug wires: Vibration damage – Constant wear and tear caused by engine vibration can loosen the electrical connection at the spark plug.
What happens when a spark plug gets cut?
Abrasion damage – When spark plug wires rub against engine parts, particularly sharp edges, it causes cuts and breaks in the insulation. Once this happens, voltage can jump to ground instead of reaching the spark plug. Use the digital multimeter, set to Ohms Ω.
Can a 6V spark plug get a good spark off?
In a 6V system, which might generate less total KV to the spark plugs, plug and wire condition might be more critical. Too much resistance might not leave enough “fire” for the plugs do get a good spark off.