Is it dangerous to drive with a bad axle?
If one of your axles is broken, do not drive the car. It’s not safe. If you notice a bumping, clicking or grinding noise when going into turns, your axle isn’t broken yet, but it’s only a matter of time. When your axle fails, it’s possible that you’ll lose control of the car, possibly causing an accident or crashing.
How much does a Jeep Grand Cherokee axle seal replacement cost?
If you don’t have a press, take the axle to any auto center, they will probably do it for $20 or nothing at all. Checked the rear differential, it was really low. Must have lost majority of the oil in the case. I have only about 10K on the oil in there, once the seal goes, the synthetic oil I used went in a hurry. Loading…
Is the rear axle seal leaking on my Jeep?
I have Appt with Jeep monday!!!Getting Driveline service plus seal done for $447 But its leaking slow…..so i’m taking it tomorrow just 300 miles to Colorado!! Am I missing something or where are you getting that it’s leaking on the wheel?
What causes a transmission fluid leak in a Jeep Grand Cherokee?
If your Grand Cherokee is slowly leaking transmission fluid from the pan directly onto the ground, the transmission leak is as serious as when it leaks onto the exhaust. You should still deal with it right away.
Is the rear axle seal leaking in Colorado?
I don’t know how far Colorado is from where you are now, but with the axle seal leaking bad enough that you have it on the tires, it might be better to just take your other Jeep.
How to replace the front axle seal on a Jeep Grand Cherokee?
2.Install the brake rotor shield to the knuckle. 3.Install the hub bearing and axle shaft assembly, or axle shaft, into the housing and differential side gears. Avoid damaging the axle shaft oil seals in the axle housing.
I don’t know how far Colorado is from where you are now, but with the axle seal leaking bad enough that you have it on the tires, it might be better to just take your other Jeep.
Do you have to replace rear axle seal?
Bearings must be replaced with the seal as there is no way to remove the old bearing without cutting it off, not to mention even if there was it would be less than smart to not replace it for no additional labor since your in there.