How to turn off the seat belt warning?
Unbuckle the seat belt, and wait for the seat belt warning light to go on. Buckle the seat belt and wait for the seat belt warning light to go off. Repeat the above two steps, buckling and unbuckling the seat belt 2 more times ending up with the seat belt buckled. Be sure to wait for the light to turn on or off each time.
How to turn off the seat belt warning / chime on a Dodge?
Pull a bunch of seat belt slack out so you can have some room to work. Turn the key to the on position (you don’t need to start the car) and wait for the seat belt warning light to turn off. Unbuckle the seat belt, and wait for the seat belt warning light to go on.
When to turn off the seat belt chime?
The chime is especially annoying if you are just driving the car into the garage at night or driving slowly in a parking lot or around your neighborhood. Only the chime will be turned off, the seat belt warning light will still work as it always did.
Is there an alarm when you unbuckle your seat belt?
This alarm produces a “dinging” noise when your vehicle is operating while the seat belts are unbuckled. Although Ford does not condone driving with your seat belt unhooked, this alarm can be disabled if you find it inconvenient.
How can I disable the seat belt alarm?
Buckle and unbuckle the seat belt three times again, ending with the belt unbuckled. Wait for the seat belt warning light to turn on, then turn off. After it turns off, buckle and unbuckle the seat belt again to disable the seat belt alarm.
How do you turn off the seat belt alarm on a Toyota Camry?
As an example, the sequence for turning off the seat belt alarm on a Toyota Camry (2004 and newer) is given below. Insert the key and turn the power on. You should not crank the engine. There is a knob on your dash panel that toggles your trip and total odometer readings.
Why does my seat belt alarm keep dinging even?
Check all wiring from the belt buckle release a the way down to under the seat; both sides…both seats They both seats could be interlinked into system; when one fails (bad connection) the other seat sensor fails also. Do not defeat the system by unplugging it under the seat!
How do you disconnect the seat belt in a car?
Disconnect the driver’s safety belt and the passenger’s safety belt. Put the key in the ignition and turn it to the “On” position, but don’t start the engine. Wait for one minute for the seat belt light on the instrument panel to turn off.