How to turn climate control back on after dead battery?
Reconnect battery, start truck (with climate control still off) run truck for 2-3 minutes. Shut truck 2nd time, start truck again, then turn climate control on and it should work, if an actuator is not bad. My Buick used to do this occassionly and that put it back to work everytime.
What to do when your climate control stops working?
Instead, we just grab a test light and look at the voltages on each fuse. All of the smaller spade-type fuses have two tiny holes on top for test points. Turn on the ignition switch and turn on any systems you can that are related to the problem, then check for those two voltages on each fuse.
Why is the climate control not working on my Mercedes?
With all the fuses working and the car only having 48K miles, I am thinking that it is just too much of a cooincidence that the climate control stopped working the day after replacing the engine harnesses. Although I just don’t get why everything tested fine right after the harness change.
When did I replace the climate control on my dash?
Recently i had the climate control on the dash replaced, about 8 months ago. 2 days ago went to place the defroster on and vent/ air didnt come out the defrost area like it sho … read more
Instead, we just grab a test light and look at the voltages on each fuse. All of the smaller spade-type fuses have two tiny holes on top for test points. Turn on the ignition switch and turn on any systems you can that are related to the problem, then check for those two voltages on each fuse.
Why does my climate control panel have no power?
Climate Control Panel Has No Power: I Have No Power to My Climate I have no power to my climate control instrument panel. What would cause this and how do I fix it? have the same problem? First suspect is a defective control module. Second suspect is a blown fuse. helpful? Would the fuse I need to replace be under the dash or in the BJB?
How do I reset the climate control on my car?
Ignition off, pull the HVAC/ECAS fuse for 10 seconds, reinstall and start vehicle without touching any controls, wait 40 seconds for the control module to self calibrate. If there is still a problem, the actuator for the temp blend door may have failed. Scan the HVAC for codes. Re: Resetting Climate Control?
What kind of wire is the climate control?
Terminal 16 is a purple / orange wire and must have 12 volts when the ignition switch is on. To check the ground wire, move the test light’s ground clip to a positive source. The easiest to find is the battery’s positive cable. Now, the test light will light up when you probe a good ground. Terminal 3 is a black wire.