How to test A NISSAN PATROL 4X4 ECU?
1. Switch ignition ON. 2. Confirm the Check Engine Lamp illuminates. (System will be in Diagnostic Test Mode I.) 1. Bridge Diagnostic Connector terminals 1 and 8. 2. Confirm the Check Engine Lamp extinguishes. 3. Wait at least two seconds. 4. Disconnect the bridge between Diagnostic Connector terminals 1 and 8.
What to do if your Nissan Patrol has a fault?
1. Bridge Diagnostic Connector terminals 1 and 8. 2. Confirm the Check Engine Lamp extinguishes. 3. Wait at least two seconds. 4. Disconnect the bridge between Diagnostic Connector terminals 1 and 8. 5. (The system will be in Diagnostic Test Mode II.)
How is trouble code displayed on Nissan OBD?
Trouble codes are displayed by the malfunction indicator lamp (MIL). The ECM fault memory can also be checked using diagnostic equipment connected to the data link connector (DLC). CAN data bus enables the engine control module (ECM) to display diagnostic information relating to immobilizer and transmission systems.
What is the diagnostic code for a Nissan check engine light?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code listfor definitions on all other Nissan diagnostic trouble codes. Manufacturer Specific Codes P1105MAP/BARO Pressure Switch Solenoid Valve
What is the diagnostic code for a Nissan?
Nissan Diagnostic Fault Codes List. Nissan Logo. P0100 Airflow Circuit Malfunction. P0101 Wrong indicator / air flow meter not adjusted. P0102 Low air mass meter reading. P0103 High air mass meter reading. P0104 Malfunction of the air mass meter.
How to clear engine OBDII Codes without Nissan consult?
ECM has entered to Diagnostic Test Mode II (Self-diagnostic results). How to clear the engine codes without a Nissan CONSULT or scan tool. Set ECM in Diagnostic Test Mode II (Self-diagnostic results). Fully depress the accelerator pedal and keep it for more than 10 seconds.
How to find OBD code on Nissan Pathfinder?
Turn diagnostic mode selector on ECU fully clockwise and wait until inspection lamps flash. Number of flashes displayed indicates corresponding mode. Note number of flashes, then immediately turn diagnostic mode selector fully counterclockwise. 3. On Pathfinder, Pickup and Van models, proceed as follows:
How long does it take for a Nissan OBD code to appear?
For example, a code 12 will be displayed by the check engine lamp flashing 1 time for approximately 1.2 seconds, followed by a .6 second pause, then 2 short flashes. Each trouble code will be displayed 3 times before the next trouble code is displayed.