How to retrieve Eaton Fuller transmission fault codes?
Place the shift lever in neutral. Set the parking brake. Turn key on with engine off. Note: If the engine is already running, you may still retrieve codes; however, do not engage the starter if the engine stalls. To Retrieve Active Codes: Key on. Turn key off and on 2 times within five seconds ending with the key on.
What causes vibration in an Eaton Fuller transmission?
Although the effects of vibration will show up in the transmission, vibration usually originates somewhere else in the drive train. Vibration can usually be felt or heard by the driver; however, in some cases, transmission damage caused by vibration will occur without the driver’s knowledge.
What causes a slipout on an Eaton Fuller transmission?
Under the right conditions, slipout will result. Some of these conditions are: Transmission mounted eccentrically with engine flywheel pilot. Excessive gear clashing which shortens clutching teeth. Incorrect adjustment of remote shift control linkage resulting in partial engagement. Also check for loose connections and worn bushings.
What’s the No Code on an Eaton transmission?
If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display. Some vehicle may be equipped with a service light.
What is the FMI rating for Eaton Fuller?
FMI – Description 0 High – most severe 1 Low – most severe 2 Erratic, Intermittent, or Incorrect 3 Voltage Above Normal 4 Voltage Below Normal
What should I do before starting an ultrashift transmission?
Read the entire driver instructions before operating this transmission. Before starting a vehicle always be seated in the driver’s seat, select “N” on the shift control, and set the parking brake. If engine cranks in any gear other than neutral, service vehicle immediately.