How to replace diff seal on Arctic Cat Prowler?
Would be a good time to check wheel bearings while you are in there. Pull wheel, pull brake caliper and hang out of the way (dont remove brakeline) To break that big nut loose I put lugs back on studs then wedge a long pry bar between 2 lugs down against the ground, heat big nut with torch then hit it with impact or long breaker.
How to remove CV axle on Arctic Cat 650?
On our Arctic Cat 650, we needed to remove the cotter pin and axle nut first before trying to remove the wheel hub. The next step is to pull the hub off and unbolt the Knuckle assembly. There are two bolts, one on top and one on bottom. This allows the knuckle to pull out toward you.
How do you replace an axle on an Arctic Cat?
The knuckle on this Arctic Cat has two bolts holding it in place. Reach for the new axle assembly and make sure to add a little differential oil or grease to the seal before reinstalling the new axle into the transmission.
How to change rear axle on side by side ATV?
Here’s just a brief but hopefully helpful guide to changing the axle in a side-by-side’s independent suspension. This happens to be an Arctic Cat Prowler but the process will be similar on most rear-axle change-outs. Bend the cotter pin straight with small pliers so it comes through the hub nut easily.
The knuckle on this Arctic Cat has two bolts holding it in place. Reach for the new axle assembly and make sure to add a little differential oil or grease to the seal before reinstalling the new axle into the transmission.
On our Arctic Cat 650, we needed to remove the cotter pin and axle nut first before trying to remove the wheel hub. The next step is to pull the hub off and unbolt the Knuckle assembly. There are two bolts, one on top and one on bottom. This allows the knuckle to pull out toward you.
Here’s just a brief but hopefully helpful guide to changing the axle in a side-by-side’s independent suspension. This happens to be an Arctic Cat Prowler but the process will be similar on most rear-axle change-outs. Bend the cotter pin straight with small pliers so it comes through the hub nut easily.
How do you install a CV axle on an ATV?
The circular clip on the axle will compress and then snap into place when it finds the cut in the receiver. This may take a little force to get the axle properly seated but most are easily installed. A broken axle cup may need a little convincing with a rubber hammer to get it out of the knuckle.