How to replace a V Star starter clutch?
How-To: V Star Starter Clutch Replacement (Sample) – YouTube http://www.howtomotorcyclerepair.com/vstarstarterclutch/Click link above for full length video and FREE service manual.The starter clutch or one way clutch f…
Where can I get a free starter clutch replacement?
Go to your local Autozone and rent a harmonic balancer puller for FREE. Yamaha updated the design of several parts in the starting system, so it is best to replace the starter, one way starter clutch, bearing, and idler gear between starter and starter clutch.
How does the starter work on a Yamaha V Star?
It turns out that this is a very common problem on the V Star model. The design of the starting system incorporates a starter gear that is always engaged with the engine. Yamaha uses a one way clutch to disengage the starter once the engine is running.
How to replace the middle drive shaft on a V-Star 1100?
1. Support bike on securely on Bike Lift to enable rear end removal. 2. Remove Rear Wheel & Swing Arm 3. Remove Speedo Sensor from bike. 4. Remove Uni Joint (should just slip off end of shaft if nut is snapped). 5. Inspect Uni-joint for damage. If badly damaged – Replace.
How to replace starter clutch on Yamaha Star 1100?
To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: hiROB1ahsL_Z4Ya8) An error occurred while retrieving sharing information. Please try again later.
How do you replace a starter clutch on a V-Star?
Holding the flywheel in place remove the nut. Then reach behind the flywheel and hold the little gear in place on the back of the flywheel. There are little springs etc. (refer to the manual) that will fall out if you do not hold this gear while sliding the flywheel off.
Go to your local Autozone and rent a harmonic balancer puller for FREE. Yamaha updated the design of several parts in the starting system, so it is best to replace the starter, one way starter clutch, bearing, and idler gear between starter and starter clutch.
It turns out that this is a very common problem on the V Star model. The design of the starting system incorporates a starter gear that is always engaged with the engine. Yamaha uses a one way clutch to disengage the starter once the engine is running.
To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: hiROB1ahsL_Z4Ya8) An error occurred while retrieving sharing information. Please try again later.
How-To: V Star Starter Clutch Replacement (Sample) – YouTube http://www.howtomotorcyclerepair.com/vstarstarterclutch/Click link above for full length video and FREE service manual.The starter clutch or one way clutch f…
How do you change a starter in a V-Star?
1. Drain the oil, and remove the starter motor 2. Remove the rear cylinder head cover to open up to the cam gear area. 3. Remove the kick stand and then the transmission cover. 4. Now remove the little cover where the clutch cable goes into and unhook the clutch cable.
How to replace a clutch on a V-Star bike?
WORK ALONG WITH YOUR REPAIR MANUAL. READ EVERYTHING THROUGH FIRST First, get your bike in a good working position. You will be removing the left side crankcase cover, small clutch arm housing cover, kick stand, and the transmission cover. Put the bike up on a lift or support it with 2×4’s.
How does the starter work on a Yamaha?
The design of the starting system incorporates a starter gear that is always engaged with the engine. Yamaha uses a one way clutch to disengage the starter once the engine is running.