How to remove the trim panel on a jagrepair XJ6?
Remove the trim panel by lifting it from beneath the rear plastic valence (Fig. 2b) and slowly pulling it from the rear toward the front (Fig. 2c). As with the XK8, it is not necessary to remove the plastic valence at the rear of the trunk. Fig. 2b XJ6 Fig. 2c XJ6
What kind of suspension does a Jaguar XJ6 have?
The rear suspension is an independent type suspension which also have coil spring/shock absorber assemblies and a lower control arm. The rear driveshaft acts as the upper control arm. Power-assisted Anti-lock Brake Systems (ABS) with four-wheel disc brakes are standard equipment on all Jaguar XJ6 models covered in this manual.
Where is the transmission on a Jaguar XJ6?
Transmissions are a four-speed automatic equipped with a lock-up torque converter. The transmission is mounted to the back of the engine, and power is transmitted to the fully independent rear axle through a two-piece propshaft.
When did Borg Warner replace the Jaguar XJ6?
In March 1970 it was announced that the Borg-Warner Model 8 automatic transmission, which the XJ6 had featured since 1968, would be replaced on the 4.2-litre XJ6 with the Borg-Warner Model 12.
How to troubleshoot XJ Series III power window circuit?
Checklist for inspection and repair of the XJ Series III power window circuits and relays. “My right side front door window came out of the track resulting in it jamming. After a few cycles of trying to free it up by alternate up and down selections on the switch, something clicked and there was no more power to the switch.
When did the Jaguar XJ6 6 cylinder come out?
Introduced in late 1968, it combined refinement, luxury, 120-mph performance, and superb handling. The signature 4.2-liter DOHC six-cylinder delivered 180 horsepower, along with four-wheel independent suspension, power rack-and-pinion steering, power disc brakes all round, and an automatic transmission.
Is the rear window on my XJ working?
The right side rear window worked before this incident and does not afterward. It’s switch connector also has continuity to ground at the proper places, but no +12v. The left side windows work fine, as does the sunroof. What am I missing? Thanks to any who can enlighten me.”