How to remove the oil pan from a Harley Davidson?
Remove the rear axle and loosen the belt and brake caliper and move the wheel maximum backward. Set some wooden planks under the engine and loosen the bolts and carefully move the oil pan backwards. Sounds like you have the removal handled and your description is fine.
What kind of Allen bit do I need to remove stock oil pan?
The screws are 1/4″ allen head and can be removed with a 3/16″ allen bit or ball allen. Once the twelve screws are removed, you will be able to slide the stock oil pan toward the primary drive side and back out of the bottom of the motorcycle.
What’s the best way to replace an oil pan?
The screws will hold the gasket in place and act as a guide as you are handling the pan section. Baker actually recommends using the longer, bottom pan, supplied hardware to aid in holding the gasket in position. The longer, bottom pan screws are easier to handle for this temporary, alignment step.
Where does the stock oil pan go on a motorcycle?
Once the twelve screws are removed, you will be able to slide the stock oil pan toward the primary drive side and back out of the bottom of the motorcycle. The stock oil pan will slide out fairly easy but now, with it out of the way, it is important to get a close look at the rear frame cross member.
Remove the rear axle and loosen the belt and brake caliper and move the wheel maximum backward. Set some wooden planks under the engine and loosen the bolts and carefully move the oil pan backwards. Sounds like you have the removal handled and your description is fine.
How to tighten the bolts on an oil pan?
Tighten the bolts to 47 Nm (35 ft. Lbs.). 4. Install the access plugs for the oil pan rear nuts, 5. Install the bracket for the starter positive cable and the transmission cooler lines to the side of the oil pan. Tighten the bolts to 12 Nm (106 inch lbs).
How do you install a new oil pan?
Install the oil pan. Refer to Oil Pan Installation. 3. Install the transmission to oil pan bolts and nuts. Tighten the bolts to 47 Nm (35 ft. Lbs.). 4. Install the access plugs for the oil pan rear nuts, 5. Install the bracket for the starter positive cable and the transmission cooler lines to the side of the oil pan.
How to remove oil pan from Chevy Silverado?
Instructions for remove bolts oil pan chevrolet silverado 4.3 1500 pick up 1999. I have 12 bolts out but can’t drop down oil pan. Please help have the same problem? You may need to remove the engine mounts and jack the engine up to gain clearance use wood blocks to hold the engine up.