How to remove and install a Kia Rio radiator?
Remove the cooling fan (A) from the radiator (B). 13. Installation is reverse order of removal. Bleed air from the cooling system. Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.) Turn off engine. Check the coolant level and add coolant if needed.
How to bleed coolant in a Kia Rio?
After draining engine coolant in the reservoir tank, clean the tank. 6. Fill the radiator with water through the radiator cap and tighten the cap. To most effectively bleed the air, pour the water slowly and press on the upper/lower radiator hoses. 7. Start the engine and allow to come to normal operating temperature.
When to add transmission fluid to Kia Rio?
Kia has been developed sophisticated transmissions through years and it is critical that you add the exact type of transmission fluid stipulated by your owner’s manual (typically in the back of the manual in a section titled Fluid Capacities.)
How to get coolant out of Kia Optima?
Make sure the engine and radiator are cool to the touch. 2. Remove radiator cap (A). 3. Loosen the drain plug (A), and drain the coolant. 4. Tighten the radiator drain plug securely. 5. After draining engine coolant in the reservoir tank, clean the tank. 6. Fill the radiator with water through the radiator cap and tighten the cap.
How do you drain coolant from Kia Rio?
1. Make sure the engine and radiator are cool to the touch. 2. Remove radiator cap (A). 3. Loosen the drain plug (A), and drain the coolant. 4. Tighten the radiator drain plug securely. 5.
How do you bleed air in Kia Rio?
Fill the radiator with water through the radiator cap and tighten the cap. To most effectively bleed the air, pour the water slowly and press on the upper/lower radiator hoses. Start the engine and allow to come to normal operating temperature. Wait for the cooling fans to turn on several times.
Where can I get additives for Kia Rio?
Additives are available from your authorized Kia dealer along with information on how to use them. Do not mix other additives. ❈ Inspect : Inspect and if necessary, adjust, correct, clean or replace.
Make sure the engine and radiator are cool to the touch. 2. Remove radiator cap (A). 3. Loosen the drain plug (A), and drain the coolant. 4. Tighten the radiator drain plug securely. 5. After draining engine coolant in the reservoir tank, clean the tank. 6. Fill the radiator with water through the radiator cap and tighten the cap.