How to install timing chain on Hyundai Accent?
Install the timing chain guide (A) and the timing chain (B). When installing a timing chain, align the timing marks on the sprockets with paint marks of the chain. Order : Crankshaft sprocket → Timing chain guide → Intake CVVT sprocket → Exhaust CVVT sprocket. 5. Install the chain tensioner arm (A). 6.
Where is the timing mark on a camshaft?
Turn the crankshaft pulley, and align its groove with timing mark “T” of the timing belt cover. Check that the timing mark of camshaft sprocket is aligned with the timing mark of cylinder head cover. (No.1 cylinder compression TDC position) Remove the crankshaft pulley bolt and crankshaft pulley (A).
What are the timing marks on a Hyundai 2010?
Looking for a pic of the timing marks for the 1.6 dohc hyundai 2010. I’ve got the crank on TDC and exhaust cam on the mark. But dont have a guide to go off for 2nd cam.
Where is the dowel pin on a Hyundai Accent RB?
Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Timing System. / Timing Chain. Repair procedures / Installation 1. Dowel pin of crankshaft should be positioned at 3° in relation to vertical center line. 2.
Install the timing chain guide (A) and the timing chain (B). When installing a timing chain, align the timing marks on the sprockets with paint marks of the chain. Order : Crankshaft sprocket → Timing chain guide → Intake CVVT sprocket → Exhaust CVVT sprocket. 5. Install the chain tensioner arm (A). 6.
Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Timing System. / Timing Chain. Repair procedures / Installation 1. Dowel pin of crankshaft should be positioned at 3° in relation to vertical center line. 2.
How big is the gasket on a Hyundai Accent?
Apply the liquid gasket (TB 1217H or LOCTITE 5900H) on the surface between the cylinder head and the cylinder block. Width : 3 ~ 5mm (0.1181~0.1969in.)
Where are the timing marks on a Kia Cee’d?
1. Dowel pin of crankshaft should be positioned at 3° in relation to vertical center line. 2. Align the TDC marks (A) of the CVVT sprockets with the upper surface of the cylinder head to make No.1 cylinder be positioned at TDC.