How to install the intake manifold in your Ford Big Block?
You can go back later when the material has dried and trim it with a razor blade for a neater-looking installation. With the intake manifold in place, thread in all the bolts by hand, snug them, and then torque to 30 ft-lbs following the tightening sequence shown in the Appendix.
How much torque does a small block intake have?
Small Block Chevy Intake Manifold Bolt Torque Specifications. 25 Ft/Lbs. Make sure you follow the sequence in a couple of steps, worry about this more on old and aluminum manifolds. Cast Iron is much more forgiving if you are unfortunate to have to use a boat anchor of an intake.
How do you remove an intake manifold on a Mustang?
Remove the nine 10mm intake manifold bolts. The two rear bolts on each side will be the hardest to remove since both are covered by convoluted tubing. On the passenger side, loosen the hose clamp on the heater hose connected to the intake manifold and position it out of your way. Have some rags ready to catch any coolant that may run out.
Can a water pump be installed with an intake manifold?
Once the intake manifold is in place, you can bolt on the water pump, installing the bypass hose as you do so. Original tower-type hose clamps replace those that were on our engine when it was removed from the car. We opted for a new set of water pump bolts, since some of the originals were quite corroded.
What to know before installing an intake manifold?
Some Common Intake Manifold Installation Tips If you have an old used manifold, before installing it, check for cracks, leaks and the threads in the thermostat housing (often a problem area) and the threads in the bolt for the distributor clamp. You don’t want to find out you have to toss in a Helicoil or other insert while it’s on the car.
How much torque does a small block Chevy intake manifold have?
Small Block Chevy Intake Manifold Bolt Torque Specifications 25 Ft/Lbs Make sure you follow the sequence in a couple of steps, worry about this more on old and aluminum manifolds. Cast Iron is much more forgiving if you are unfortunate to have to use a boat anchor of an intake. Some Common Intake Manifold Installation Tips
How much torque does a performer manifold torque?
Torque all of the manifold bolts in two steps by the sequence shown in Figure 1 to 25 ft/lbs. • THROTTLE BRACKETS:Due to the design of Performer manifolds, the throttle and kickdown bracket on some vehicles may require modification to fit.
What do I need for intake torque sequence?
Make sure you follow the manufactures instructions for the proper procedures and torque specs if they have specific values as many do. You will need the usual things for the installation, including the intake gaskets, end seals if you desire to use them, possibly thermostat housing gasket and any other small parts along the way.