How to install an engine block heater on a Nissan?
3. Apply a thin layer of gasket sealant (Nissan P/N 999MP-A7007) on both sides of the gasket. Slide it over the engine block heater threads. 4. Install engine block heater to engine block being careful not to damage the threads. Torque heater to 32 + 4 ft.lb (4.5 + 0.5 kg.m). 3/10 5.
Where to connect power cord to engine block heater?
5. Connect power cord to engine block heater and route cord as follows: A. From engine block heater route cord down, between drive shaft and engine block, toward front of the vehicle between exhaust pipe and engine oil pan (Figure 2). Attach cord to engine block ear on left side of compressor with a tie wrap.
How to remove freeze plug from engine block heater?
Remove freeze plug by positioning a flat blade screwdriver against the plug’s recessed area and hammering it repeatedly with very short strokes until the freeze plug is loosened and turns. (Do not hammer freeze plug on the edges as this could damage engine block.) Then remove plug with needle nose or combination pliers. 2.
How to replace block heater in Nissan TSB ntb17?
Shame on you, salted roads of Northeast Ohio!! 4) The replacement aluminum coolant pipe needs you to lubricate the O-ring with coolant and then push and shove it into the bung on the engine. I found through experience that you will want to NOT bolt it down until after getting the hoses back on – so at first, it should be naked:
3. Apply a thin layer of gasket sealant (Nissan P/N 999MP-A7007) on both sides of the gasket. Slide it over the engine block heater threads. 4. Install engine block heater to engine block being careful not to damage the threads. Torque heater to 32 + 4 ft.lb (4.5 + 0.5 kg.m). 3/10 5.
5. Connect power cord to engine block heater and route cord as follows: A. From engine block heater route cord down, between drive shaft and engine block, toward front of the vehicle between exhaust pipe and engine oil pan (Figure 2). Attach cord to engine block ear on left side of compressor with a tie wrap.
How much does a Nissan Frontier block heater cost?
There are two part numbers you need: part number for the heater is 110016P700 p/n for the cord is 24076EC300. I called for a US friend that has and Xterra, I was quoted $59.94 for the heater and $60.01 for the cord.
Remove freeze plug by positioning a flat blade screwdriver against the plug’s recessed area and hammering it repeatedly with very short strokes until the freeze plug is loosened and turns. (Do not hammer freeze plug on the edges as this could damage engine block.) Then remove plug with needle nose or combination pliers. 2.