How to identify the rear axle on a Jeep Grand Cherokee?

The video will show you where you need to look beneath the vehicle to find out which style of rear axle your Jeep Grand Cherokee has. You’ll be shown where to clean the dirt off of a specific area of the axle to obtain this important information.

How big are the wheels on a 1990 Jeep Cherokee?

It has been corrected. For 1990 Jeep Cherokee 15″ wheels offset is 25 mm. I’m looking to put a 18″ on my jeep … Hi,Jay,Can you explain your questions?

What kind of rear axle does a Jeep Wagoneer have?

XJ Cherokee/Wagoneer: 1987-1989 (some say up until 1990) XJ Cherokees with the Tow Package sometimes came with the Dana 44 rear axle. These are now hard to come by because of Wrangler and Cherokee owners using them to upgrade their weak Dana 35s and because it’s an easy bolt-in swap for Cherokees and Wranglers.

What kind of axle does a jeep 30 have?

Model 30: Drive-type, full floating axle with open end steering knuckles mounted on ball studs. Model 30 Front Axle: CJ-5, CJ-7, Scrambler, YJ, XJ and TJ.

How big is the rear axle on a Jeep Wrangler?

The YJ Dana 30 hold a reverse cut ring and pinion, but the TJs do not. Both TJs and YJs, however, use a 5×4.5 inch bolt pattern. Dana 35: This was an axle size used on most Jeep rear axles. They had a ring gear diameter of 7 and 9/16 inches. They came with either a 3.21 or 4.10 gear ratio.

When to change the axle on a jeep?

However, many jeep owners still believe swapping a new, beefier axle is more cost effective and better. As a general rule of thumb, most owners agree that once a jeep has been modified to run 32″ or 33″ tires, it is time to start thinking about upgrading the rear dana 35.

Model 30: Drive-type, full floating axle with open end steering knuckles mounted on ball studs. Model 30 Front Axle: CJ-5, CJ-7, Scrambler, YJ, XJ and TJ.

What’s the rear end of a jeep Dakota?

But ive also heard that its an 8.75 rear end. But it does NOT share any parts with standard 8.25 parts from XJ Cherokees or Dakotas etc. So what do i look for when looking for parts such as an off road differential cover/gasket set (lub locker re usable gaskets) etc?

How many seats does a Jeep Grand Cherokee have?

Overview Seats 5 Drivetrain RWD Towing Capacity 3,500 lbs. Payload Capacity 1,180 lbs. Combined MPG

How big is the ground clearance on a Jeep Grand Cherokee?

21.1 gal. 21.1gal. Ground clearance (max.) 21.1 gal. Wondering which configuration is right for you? Our 2008 Jeep Grand Cherokee trim comparison will help you decide.

Where is the track bar on a jeep?

A track bar works by two attachment points – one found on the frame/body and the other on the adjacent side of an axle assembly. Those two attachment points are connected by a link which is the track bar.

How big is the universal remote transmitter on a Jeep Grand Cherokee?

21.1 gal. 21.1 gal. universal remote transmitter (for garage door, security system, etc.) .41 cd. .41 cd. .41 cd.

What kind of engine does a Jeep Grand Cherokee have?

Engine Base engine size 3.7 l Base engine type Gas Cam type Single overhead cam (sohc) Cylinders V6 Horsepower 210 hp @ 5200 rpm

What kind of axle does a Jeep Wrangler have?

TJ Wrangler:1997-2006 Rear 3.73 ratio Dana 44 optional on Sport and Sahara models, also standard on X model Rocky Mountain Edition. 2003-2006 Rubicons also come with 44’s front and rear, and the rear Dana 44 has been an option for TJ’s for quite some time.

What kind of axle lubricant does a jeep use?

Front Axle Lubricants: Jeep Axle Lubricant or equivalent of SAE 85W-90, API grade GL-5 quality, Grade MIL-L-2105C. Dana 35 Rear Axle was used by Jeep for the XJ Cherokee 1984-97, MJ Comanche 1986-92, YJ Wrangler 1987-95, TJ Wrangler 1997-98, and Wagoneer 1984-97.

How can I tell if my Jeep has a Dana axle?

The illustration below will help identify the Dana Axle in your Jeep. The model number and date are self explanatory. The Bill of Materials (B.O.M) number is stamped on the right or left hand tube of the driving axles and with the help of a Spicer catalog you should be able to get all the specs and part numbers for the axle.

When do you need to replace axles on a Jeep Wrangler?

Here is how: A Jeep Wrangler’s axles are a popular swap project. Sometimes it’s an upgrade, and other times it’s because you destroyed your current axles in the last trail run and you need to replace them. When it comes around to replacing an axle, you will need to know what you have and what you will be replacing.

When to replace rear differential on Jeep Cherokee?

Finally the dealer figured out that the rear differential needed to be replaced at only 15k miles. At approximately 25k miles, I was hearing a whistling sound on the driver side front end when cruising at aprox. 20mhp or less. I took it to the dealer mult.

When did Jeep change the body of the XJ?

In 96 the body structure was strengthened some although it was not noticeable in appearance. In 97 the body (and interior) was redesigned to freshen it up a bit. Most noticeably it gave the body smoother lines by changing the bumpers, flares, and moldings.

How do you identify your Jeep differential identifier?

How Do You Identify Your Jeep Identifier? There are two ways to discern one differential from the rest. The first way is to use the axle numbers. This can come either in the form of an axle tag which is bolted onto the axle via the differential bolts, or via an axle stamp pressed into the differential cover itself.

Where do you find the axle number on a jeep?

The first way is to use the axle numbers. This can come either in the form of an axle tag which is bolted onto the axle via the differential bolts, or via an axle stamp pressed into the differential cover itself.

How do you remove a door from a Jeep Cherokee?

Pull the electrical through. Disconnect the door retainer that holds the door open either by hammering the pin upwards, by unbolting it, or by cutting it off. Unbolt the door from the hinges or in the older Jeep Cherokee’s case, cut the hinges with a sawzall.

How big is the cargo area in a 1999 Jeep Laredo?

Interior Front head room 40 ” Rear leg room 35.3 ” Luggage capacity 39.0 cu.ft. Maximum cargo capacity 72.3 cu.ft. Standard seating 5

How tall is the Jeep Grand Cherokee Laredo?

Exterior Length 181.5 ” Body width 72.3 ” Body height 69.4 ” Wheelbase 105.9 ” Curb 4,130 lbs.

How big is a 1999 Jeep Grand Cherokee?

20.5 gal. Many sport-utility buyers like to plant their right feet deep into the accelerator and feel instantaneous movement. Do this in Jeep’s redesigned ’99 Grand Cherokee Limited and it takes off a bit slower than last year’s model.

What is the fluid level on a Grand Cherokee NV146?

NOTE: The fluid full level on the NV146 is 25-35 MM (0.98-1.38 In.) below the bottom of the fill plug. This is different from the other Grand Cherokee applications. It is important that the transfer case not be overfilled and that the correct fluid is used.

What kind of fluid does a Jeep Grand Cherokee use?

This is different from the other Grand Cherokee applications. It is important that the transfer case not be overfilled and that the correct fluid is used. ATF+4 MUST always be used in vehicles that were originally filled with ATF+4. ATF+4 is compatible with ATF+3 and can be used to top off vehicles that currently have ATF+2 or ATF+3.

What kind of differential does a Jeep Grand Cherokee use?

In 4-Lo, the front and rear axles are locked together through a 2.72 reduction gear ratio. The NV247 transfer case is mated to front and rear axles containing Jeep’s Vari-Lok differentials. Vari-Lok differentials also use a gerotor to transfer torque between the wheels on either side of the axle.

What kind of 4 wheel drive does a Jeep Grand Cherokee have?

It was replaced in the 2005 Grand Cherokee by the Quadra-Trac II system featuring the NV245 transfer case with 4WD Auto mode and in the 2008 KK Liberty by Selec-Trac II using the MP3022 transfer case. Selec-Trac II uses a console mounted switch to control the MP3022 transfer case.

What kind of suspension does a Jeep Grand Cherokee have?

It was their flagship model and nearly identical to the 2004 Grand Cherokee Limited in looks and equipment, including the solid axle suspension, choice of 4wd systems, body color cladding, alloy wheels, Chrysler sound systems, and Chrysler automatic climate controls.

What kind of axles does a Jeep Wrangler use?

The Three Wrangler Dana Axles. The Dana portion is the nameplate of Dana Inc., who is the manufacturer of the Jeep axles. There have been a few different axles used in Wranglers over the years with the Dana 44 being the most popular.

What’s the difference between the Dana axles and axles?

The Dana 30 is once again at the front, but all Rubicon JKs will have Dana 44s in the front and rear. JL Wranglers have a Dana 30 up front and a Dana 35 in the rear. The exception as always is the Rubicon (44s front and back). What’s the Difference Between the Dana Axles?

How are axle lengths measured on a wrangler?

Measuring front the center to the end of the shaft will get you the inner and outer axle lengths. C-clip axle shafts and semi-float axle shafts are measured slightly differently than the full-float shafts. C-clip and semi-floats are measured from the end of the splines to the front of the mounting flange.

What’s the weak part of the ZJ Grand Cherokee axle?

Many people upgrade this axle with 30 spline axles and lockers. The upgrade many times is known as a SUPER 35 kit. The weak part of this axle is the axle tubes. Under extreme pressure they flex which results in broken axles or pinion failures. Stock ZJ Grand Cherokee Axle info: Lug Pattern: 5 on 4.5″ Notes: Stronger the earlier D30’s.

Can a wheel hub assembly be a problem?

Finally, if you hear a clicking sound that increases in speed as the vehicle accelerates, this could be a problem with the wheel hub assembly as well. In this case, the brake caliper will move up and down and hit the top of the wheels as the vehicle drives down the street.

How do you remove the rear axle from a jeep?

If you forgot your penetrating oil at home use anything handy like transmission fluid or brake fluid. Remove the shock bottoms with a ¾” socket. Remove the rear driveshaft end from the axle with an 8mm socket wrench and a screwdriver to hold the shaft from spinning.

What kind of axles does a Jeepster Commando have?

Jeepster Commando: Dana 44 rear axle on all Jeepster Commandos, 67-69 had tapered axle Dana 44 and the 70-71 had the flanged Dana 44 axles. YJ Wrangler: Some early YJs also had a Dana 44 in the rear, but this option was only available in Canada.

What kind of axle does a Jeep Grand Cherokee have?

ZJ Grand Cherokee: 1996-1998 ZJs with the V8 and 1999-2004 WJs with the V8 had a Dana 44 with an aluminum centers. The aluminum Dana 44 is a C-clip type axle and it doesn’t use standard Dana 44 components.

How to replace rear axle seal on Jeep Grand Cherokee?

This video shows you how to go through the process of replacing a leaking rear axle seal on a WJ (1999-2004) Jeep Grand Cherokee. This procedure would be very similar for many other solid axle Jeeps as well as many other vehicle makes and models. Loading…

How are axles measured on a Wrangler model 44?

The non-Rubicon model 44s are the same length. Axle shafts with a u-joint in the center are measured from the center of the u-joint. Measuring front the center to the end of the shaft will get you the inner and outer axle lengths. C-clip axle shafts and semi-float axle shafts are measured slightly differently than the full-float shafts.

How big is the rear differential on a Jeep Grand Cherokee?

We are proud to offer this remanufactured 8.25-Inch Rear Differential for the 2005-2008 Jeep Grand Cherokee with Four-Wheel Drive . This rear diff is configured with a 3.07 gear ratio Jeep Grand Cherokee. This rear diff has been rebuilt by…

Are there rear differentials for the Jeep Wrangler YJ?

We are proud to offer this remanufactured Dana 35 Rear Differential for the 1987-1995 Jeep Wrangler YJ SUV with Two-Wheel Drive or Four-Wheel Drive. This rear diff is configured with a 3.07, 3.73, or 4.10 gear ratios, and a limited slip… Tracking down remanufactured Jeep differentials for sale to get your Jeep back up and running?

How can you tell if a Dana axle is under a jeep?

You may be unsure which axle is under your Jeep, or maybe you’re purchasing a Jeep and want to know which axle it has. There are a few things that can help you tell if the axle is a Dana 35 or a Dana 44. The easiest way to tell these axles apart is to look at the shape of the differential cover. The Dana 35 cover is pretty much perfectly round.

How much does a 1999 Jeep Cherokee weigh?

Gross vehicle weight: 4,550 lbs. Max cargo capacity: 69 cu.ft. Payload: 1,151 lbs. Towing Capacity: 2,000 lbs.

What are the specifications of a 1998 Jeep Grand Cherokee?

Trans Description Cont. Again Electronic Looking for other models of the Jeep Grand Cherokee?

How to bypass the neutral switch on a Jeep Cherokee?

Simply find a 12 volt source under the hood, run a #12 or #14 fused wire thru the firewall, to a momentary push button mounted under the dash (I used a little horn button), then run another wire from the other terminal of the same horn button, thru the same hole in the firewall, and down to the small electrical terminal on the starter solenoid.

Navigation