How to fix idle and stalling on a Jeep Wrangler?
1. Remove wire clip from throttle linkage side of carburetor (see picture) 2. Remove 1/4″ bolt from opposite side of choke rod (see second picture) and remove little flange thing the bolt held on (you may need to tap it with a screw driver, or something similar) 3.
Why does my Jeep Cherokee keep stalling?
While certainly frustrating, these stalls can also have serious consequences. Here is why your Jeep Cherokee keeps stalling: Many stalling problems can be attributed to the PCM or crankshaft sensor and there are steps you can take to fix these issues yourself or at the very least point your mechanic in the right direction
When did the stalling problem start in my car?
Most stalling problems pertain to model years starting from the mid-1990s all the way to recent model years, and have occurred with virtually every trim level.
How many miles does a Jeep Cherokee take to stall?
Jeep Cherokee XJ’s and Cherokee KJ’s with less than 25,000 miles have experienced stalling problems, but most cases seem to involve vehicles with 75,000 miles or more on them, and it is with particular reference to these older vehicles that the PCM is most relevant.
What happens when engine RPM drops below 800?
However, when the engine RPM drops below the normal range of 800 RPM (for most cars), it is more than likely that you are dealing with an IAC valve problem. In cases where this valve is clogged or is failing, your vehicle will stall instead of slowing to an idle after the release of the throttle.
How does the idle speed of a car work?
This valve is controlled by the vehicle’s computer which will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed.
Why does my Jeep stall when I start the engine?
If it starts, the fuel pump is the problem. If not, the engine should be checked for spark. It could be a sensor or computer-related problem. To be absolutely sure, raise and support the back of the Jeep on jack stands, unless the height allows you to crawl under the back without raising it.
What is causing my Jeep to die ( stall ) at idle RPM’s, or up?
WHAT IS CAUSING MY JEEP TO DIE (STALL) AT IDLE RPM’S, OR UP… Hello and welcome to Just Answer. I am sorry to hear about your problems with this vehicle. If you like, we can try to do a few tests to isolate the cause of the problem. Your truck uses a device called an IAC valve to control idle speed.
Why does idle drop when the AC is on?
if the a/c is overcharged or the expansion valve isnt equalizing it can cause excessive resistence of the compressor wheel and excessive drag on the motor. Ive seen it quite a bit Loading… I have the same problem with my idle dropping when the AC is turned on and it was the ISC.
What are the symptoms of a failing idle air control valve?
Symptoms of a failing idle air control valve. A faulty idle air control (IAC) valve can cause a number of problems with your vehicle: 1. Incorrect idle speed: An IAC valve that sticks in the closed position will create an idle speed that’s too low. Your RPMs will drop way down the car may feel like it’s about to stall.
However, when the engine RPM drops below the normal range of 800 RPM (for most cars), it is more than likely that you are dealing with an IAC valve problem. In cases where this valve is clogged or is failing, your vehicle will stall instead of slowing to an idle after the release of the throttle.