How to fix Arctic Cat EFI 4×4 wiring issues?
Disconnect the tail light and take off the gas cap. The plastics should come off. Check where the wiring harness leaves the fuse block and wraps around the frame. For the front remove the cover for the radiator and the cover where the steering stem is. You should be able to see almost everything from there. Let me know if you find any bad wires.
Can a arc fault interrupter trip a circuit?
Arc fault circuit interrupters (AFCIs), if your home has them and they’re up-to-date, will trip a circuit if a spark forms along faulty wiring. The Fix: This is basically the same as the above two. If your home has AFCIs, the fault should have tripped the circuit.
Which is Shell Rotella T6 for Arctic Cat 700?
I’m wanting to run Shell Rotella T6 synthetic in the 700 Griz but I can only find it in either 0W-40 or 5W-40 weights, and the manual says it’s ok to use everything BUT those weights…5W-30, 10W-30, 10W-40, 15W-40, 20W-40 and 20W-50. AL righty I did some trading around this weekend and ended up picking up a few 4 wheelers for cheap.
Is there a problem with my Arctic Cat ATV?
Dying Problem – 09 700 H1 – Please Help! – Arctic Cat ATV Forum – QUADCRAZY Dying Problem – 09 700 H1 – Please Help! Do you own an ATV or UTV? Join our Forum!
What to do if your Arctic Cat dies?
Go ahead an add a little Seafoam again, but don’t use too much, keep in mind this stuff is formulated to be used 1oz per gallon of fuel. Run the machine around for a bit, if you still have problems take it to the dealer and let them deal with it.
Why does my Arctic Cat die at idle?
After a few more dies at idle while warming up, backing out, etc. I finally got it running long enough to ride around the neighborhood. It hesitated or sputtered a couple of times while giving it throttle at 30-40 MPH, but seemed to be running a little better after a while.
Why does my Wildcat 700 EFI keep going dead?
My battery on my 94 wildcat 700 efi keeps going dead and it is a brand new battery. i tested it after charging it every time and it says 12.70 volts. it runs for about 2 or 3 min. and then doesnt have enough power to power the fuel injection. so what could be the problem?
What’s the EFI code on my Arctic Cat?
Has EFI code. Hi guys I’m new here I live in Colorado and I have a 2009 atric cat 550 h1. It has a EFI code on screen. I have good fuel pressure and a new spark plug. It will turn over just fine but no fire.
What do I do if my Arctic Cat won’t start?
The EFI icon will flash. 1. Make sure the ignition switch is in the OFF position; then remove the seats. 2. Locate the diagnostic plug next to the PDM; then remove the black rubber cap. 3. Connect the Test Plug from Test Plug/Error Code List to the diagnostic plug.
How to fix idle issue in Arctic Cat Prowler?
1. With the test plug connected to the diagnostic plug and the drive select switch in the 4WD position, hold the reverse override switch down and turn the ignition switch to the ON position. 2. After ten seconds, release the reverse override switch and turn the ignition switch to the OFF position; then turn the ignition switch to the ON position.