How to check transmission fluid in Honda Fit?
Honda Fit: Transmission Fluid. Check the fluid level with the engine at normal operating temperature. 1. Park the vehicle on level ground. Start the engine, let it run until the radiator fan comes on, then shut off the engine. For accurate results, wait about 60 seconds (but no longer than 90 seconds) before doing step 2.
Where was the Honda Fit transmission problem found?
Luckily car was stopped at a stoplight, otherwise this could have been very dangerous. Car was immediately immobilized. Car was towed to the local Honda dealer and then to a transmission shop where the attached pictures were taken. Hundreds of metal shards were found inside the pan.
How much does a Honda Fit transmission cost?
Honda is aware of this and still allows an unsafe car to be driven without recalls or warnings. Honda wanted almost $ 5,000 to repair this , but the local transmission shop gave me an estimate of $1754 for a used 2017 transmission. . . See all problems of the 2015 Honda FIT .
Are there any problems with the Honda Fit?
Honda FIT owners have reported 6 problems related to transmission failure (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Honda FIT based on all problems reported for the FIT. I bought a 2015 Honda Fit.
What kind of transmission fluid does a Honda Fit Use?
Pour the fluid slowly and carefully so you do not spill any. Clean up any spill immediately; it could damage components in the engine compartment. Always use Honda ATF-Z1 (automatic transmission fluid). Use only Honda Genuine ATF-Z1 (Automatic Transmission Fluid). Do not mix with other transmission f luids.
How to check fluid level in Honda Fit?
Check the fluid level with the engine at normal operating temperature. 1. Park the vehicle on level ground. Start the engine, let it run until the radiator fan comes on, then shut off the engine. For accurate results, wait about 60 seconds (but no longer than 90 seconds) before doing step 2.
What kind of oil to use on Honda Fit?
Put a new washer on the filler bolt, then reinstall the filler bolt and tighten it securely. If Honda MTF is not available, you may use an SAE 10W-30 or 10W-40 viscosity motor oil with the API Certification seal that says ‘‘FOR GASOLINE ENGINES’’ as a temporary replacement.
How do you change the transmission on a Honda CRV?
Start the engine, let it run until the radiator fan comes on, then shut off the engine. For accurate results, wait about 60 seconds (but no longer than 90 seconds) before doing step 2. 2. Remove the dipstick (yellow loop) from the transmission, and wipe it with a clean cloth.