How to avoid YouTube recommendations for GMC Terrain?
(Playback ID: O4vAIiG4OreFY7_y) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
When to replace an electronic brake control module ( EBCM )?
When this occurs, you’ll have to replace the electronic brake control module. The EBCM is typically installed in the engine compartment on most vehicles made after 1995. It’s attached to a series of electrical harnesses that are attached to sensors that send data to the EBCM.
How to tell if your EBCM needs to be replaced?
Noted below are some signs you can watch for that may signal that your EBCM has stopped working prematurely and will need to be replaced: The ABS light illuminates on the dashboard. Typically the first indicator that the EBCM is damaged, is that the ABS system light will illuminate on the dashboard.
How do you install an EBCM on a car?
The steps for installing the new EBCM are in reverse of the removal. Follow the following guidelines when installing the new unit on your vehicle: Place the new EBCM onto the mounting plate. It should snap into place with the male electrical fittings on the bottom of the mounting plate Step 8: Follow start pattern for tightening screws.
Why does my GMC Terrain have no stability?
Note: The latter two conditions correspond with no reported EBCM / ABS / Stability DTCs set current or history. These conditions may be caused by single or multiple pieces of ferrous metallic debris stuck to the wheel speed sensor magnetic encoder ring. Inspect and clean debris from the Encoder Ring.
What is DTC u0415 on GMC Terrain?
This will be accompanied with the Power Steering Control Module setting DTC U0415. This is a normal default action with the loss of a Wheel Speed Sensor signal. If DTC U0415 remains after removal of the Wheel Speed Sensor debris, refer to published diagnostics.
Where is the wheel speed sensor on a GMC Terrain?
1. Locate the affected rear wheel speed sensor (s) (WSS) harness connector, located on the upper control arm. 2. Disconnect the harness from the wheel speed sensor lead. Object ID: 3344325Click here for detailed picture of the image. 3. Release the two harness retainers from the control arm.
When this occurs, you’ll have to replace the electronic brake control module. The EBCM is typically installed in the engine compartment on most vehicles made after 1995. It’s attached to a series of electrical harnesses that are attached to sensors that send data to the EBCM.