How to adjust the front seat in an Audi A4?
– Press the top or bottom part of the adjuster switch 4 to move the lumbar support upwards or downwards as required. – Pull the lever 5, fig. 75 up or down repeatedly (i.e. pump the lever). – Lean forwards to take your weight off the backrest. – Turn the adjuster wheel 6, fig. 75 to set the angle of the backrest as required.
Is there a way to adjust the seat?
It is possible to adjust the position and shape of the seat manually so that you can travel in a safe and comfortable sitting position. Before adjusting your seat, please read and observe the warnings ⇒ . – Lift the lever 1 ⇒ fig. 75 and move the seat to the desired position.
How do you move the front seat back?
– Lift the lever 1 ⇒ fig. 75 and move the seat to the desired position. – Then release the lever 1 and move the seat further until the catch engages. – Lift the control 2 below the seat cushion. The front seat cushion will spring forward. – Slide the seat cushion back to the normal position after each use.
How do you lower the seat in a jeep?
When the lever will no longer move downward, the seat has reached its maximum height. Lift the lever up to lower the seat height if it is too high. Crank the Jeep’s engine. The ignition must be “On” for you to adjust the seat.
How do you adjust the seat in a car?
To adjust the seat do the following: •Move the seat forward or rearward by sliding the control toward the front or rear of the vehicle. •Raise or lower the seat cushion by sliding the control up or down. •Raise or lower the front portion of the seat by sliding the front part of the control up or down.
Who is the owner of the Pontiac Grand Prix?
2004 Pontiac Grand Prix Owner ManualM GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem and the name GRAND PRIX are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed.
How do you move a power seat forward?
By doing so when you activate the middle motor the seat will move forward or backwards assuming that the front motor connector has a problem.