How often should you change your brakes Hyundai Elantra?
2020 Hyundai Elantra brake pads usually last between 30,000 and 70,000 miles depending on your driving habits. If you commute in heavy traffic and use your brakes often, you’ll need to get an inspection more frequently.
Why is my Hyundai Elantra engine stalling out?
This can be caused by the fuel pump or fuel filter. If your Hyundai Elantra’s engine timing is off, it’s going to stall out, misfire, and altogether not run properly. Here are some of the more common causes of an engine timing problem: VVT Problem – Many modern engines are equipped with Variable Valve Timing.
Why does my Hyundai Elantra make a ticking noise?
In this video, we will demonstra a common problem on Hyundai Elantra with 1.8 engine. Our Hyundai Elantra has 69k miles and it developed an engine ticking noise. Especially when it is cold you can hear the ticking / knocking more. I did some research and this seems to be a common problem and most likely it is a piston slap.
Where is the throttle position sensor on a Hyundai Elantra?
Your Hyundai Elantra uses a series of complex sensors to report what is going on to the ECU. The ECU then uses this information to adjust the timing, air fuel mixture, and more. When one of them goes wrong, it can lead to stalling for sure. Throttle Position Sensor – The throttle position sensor is typically located on the gas pedal.
Why does my Audi A4 stall when I start the car?
Oxygen Sensor – The oxygen sensors measure the exhaust gasses after they exit the combustion chamber. The ECU uses this data to make adjustments to the air/fuel mixture. If one of them has gone bad, then it could lead to stalling.
Why does my Hyundai Elantra stall at stop signs?
My 2012 Hyundai Elantra would stall at stop signs and lights. It would stop and start again. . I went to Hyundai to check it out and they said it was the fuel pump. The next day I was driving on the highway and turning off the highway my car stalled out and when I tried to pull over on the side of the road the brakes were hard to press.
Can a 2004 Hyundai Elantra have a brake problem?
Your 2004 does not require the use of a force push/pull gauge to adjust, repair or check the emergency brake. It is specific to some 2006 and later, because this tool is used to inspect, adjust and repair the emergency brake. OWNERS SHOULD CHECK THEIR ON-LINE MANUAL FOR THE EXACT DETAILS.
What should I do if my Hyundai Elantra is dragging?
Step 1. Block the front tires so the vehicle will not roll. Step 2. Raise the vehicle as if you were going to change the drivers side rear tire. Step 3. Rotate drivers side tire while the brake is in the released position. If you feel any drag or hear a rubbing noise, your emergency/parking brake may be dragging.
Why does my Hyundai Elantra not have a push pull gauge?
OWNERS SHOULD CHECK THEIR ON-LINE MANUAL FOR THE EXACT DETAILS. Why they do not have the tool, look at the ESSENTIAL SERVICE TOOL SURVEY FOR 2008 (on line) not a listing for a force push/pull gauge anywhere.