How much oil does a DT 466 take?
Fill engine with 28 quarts of engine oil with oil fill funnel and reinstall oil fill cap. Start engine to let the oil circulate (Check for any leaks or abnormalities while running) and shut the engine back down.
How many liters is a DT 466 engine?
The International DT466 engine is a 7.6-liter truck engine used in school buses, farm equipment, dump trucks and construction equipment. It also is utilized in the International CXT, a pickup truck built on the International 20-ton hauler platform.
How many miles can you get out of a DT466 engine?
the average 466 will run 450 – 550k befor needing a rebuild @ about $7k. however, the injection pump which is mechanical is very expensive to have rebuilt or replaced. and they usually don’t last as long as the engine.
How much oil does a maxxforce DT hold?
Maxxforce 11 Specs and Dimensions Bore and stroke are 4.72 inches and 6.10 inches. The compression ratio is 16.5:1. Total dry weight of the engine is 2,400 lbs. Oil capacity is 42 quarts.
How much oil does a DT530 hold?
The DT530 is available at ratings of 275 hp, 300 hp, or 330 hp. Engines have been enhanced to improve performance and serviceability in the new truck line. Oil capacity has been increased to 30.3 quarts, and glass fiber content in the oil filter has been raised from 7% to 15%.
How many quarts of oil does a bus take?
A propane oil change takes seven quarts of oil: A diesel engine oil change requires 17-36 quarts of oil.
What kind of oil to use in DT466?
If you cannot find a CI 4 As an alternative you can use 10% 20/50 engine oil or 1/2 gallon of Lucas to every ten gallons of oil if you have higher miles. I would also check the injectors, the ICP sensor and the cam crank sensor.
Is the International Truck 466 a good motor?
Overall the 466 is a good motor, it always starts and has alright power, but once they get up there in miles they become painfully under powered. I think the best you can get out of a 466 is 200 HP maybe a bit more. The 6+1 transmission helps but I have not heard really good things about it.
How many horsepower does an International DT466 have?
Most DT466’s are under 250 HP, and the models with electronic fuel injection of that era were designated DT466E. The ’95 probably has mechanical fuel injection, and would be of lesser HP. If you can get the serial number of the engine, an International dealer can run it through their computer and tell you all of its sepcs.
Why do I have oil pressure problem on my DT466?
Some of the fault codes you have could be from problems that were repaired long ago and no one bothered to clear them. to the injector harness is a problem area on a DT466E. It wears from vibration and can cause a lot of problems. I have seen the connector wear enough to fall off of it’s mating connector and the engine die in the middle of nowhere.