How much is a tie rod for a 2007 Pontiac G6?
2007 Pontiac G6 Tie Rod End – from $33.49+ | AutoZone.com.
How much is tie rod for a Pontiac G6?
The average cost for a Pontiac G6 tie rod replacement is between $114 and $123. Labor costs are estimated between $35 and $44 while parts are priced at $79.
What should the inner tie rod torque be?
You will need to jack the car up first. Tighten the nut to 30 N.m (22 lb ft) plus 120 degrees . Visually inspect to ensure that 2 1/2 to 4 1/2 threads are visible past the nylon washer. Tighten the inner tie rod to 100 N.m (74 lb ft). Please let us know what happens so it will help others.
What are the torque specs on a Pontiac?
Torque Timing Cover to Intake Bolt first, THEN torque remaining Intake Manifold Bolts
What’s the torque limit on a General Motors car?
TORQUE SPECIFICATIONS. 1. Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 37 ft-lbs (50 N-M). Upon initial installation of replacement ball joint, tighten nut to to 81 ft-lbs (110 N-m).
How does a GM tie rod get crimped?
If you only have two flats on the backside, that is the GM design that gets crimped. You will get a set of five or six crow’s foot inserts with a socket they fit into. Use the one that is the right size, then slide the socket over it and the tie rod, and lock it in place with the ring on the end.
You will need to jack the car up first. Tighten the nut to 30 N.m (22 lb ft) plus 120 degrees . Visually inspect to ensure that 2 1/2 to 4 1/2 threads are visible past the nylon washer. Tighten the inner tie rod to 100 N.m (74 lb ft). Please let us know what happens so it will help others.
Pontiac Engine Torque Specs Bolts or Parts Lube or Sealer Torque to: Rocker Studs (screw-in) Engine Oil 55 ft-lbs. Rocker Arm Nuts (Non-Adjustable Rockers) Assembly Lube 20 ft-lbs. Oil Pump Bolts Engine Oil 30 ft-lbs. Oil Pump Cover Bolts Engine Oil 15 ft-lbs.
How much torque do you put on a General Motors car?
Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 37 ft-lbs (50 N-M). Upon initial installation of replacement ball joint, tighten nut to to 81 ft-lbs (110 N-m). 2. Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 48 ft-lbs (65 N-m). 3.
If you only have two flats on the backside, that is the GM design that gets crimped. You will get a set of five or six crow’s foot inserts with a socket they fit into. Use the one that is the right size, then slide the socket over it and the tie rod, and lock it in place with the ring on the end.