How much horsepower does a Saturn SL2 have?
The SL2 featured an upgraded, dual-overhead-cam version of the same four-cylinder engine. It generated a relatively robust 124 horsepower at 5,600 rpm and 122 foot-pounds of torque at 4,800 rpm.
What kind of car is the Saturn L series?
While still not an SUV, the L-Series was a midsize sedan — a good step up from the S-Series. But while the S-Series was an original in-house design by Saturn engineers, the L-Series was little more than a badge-engineered Opel Vectra.
When did the Saturn’s series get a makeover?
S-Series sedans and wagons were given an exterior makeover in 1996, followed by the coupes in 1997 (sadly losing the pop-up headlights). Unfortunately, this makeover went only skin deep, with little more than minor changes under the new plastic skin.
When did the Saturn’s series Wagon come out?
In 1993, a wagon was added to the S-Series range, as well as a version of the coupe with the less powerful single overhead cam engine. This engine’s output was increased to 100 hp in 1995, which was also when the S-Series interior was given a significant makeover.
What kind of engine did the Saturn SL2 have?
It produced 85 horsepower, which is meager by today’s standards but on par with the 88-hp Ford Escort LX of the time. The higher-level SL2 and the sporty SC coupe received a dual overhead cam engine, with a bump to 124 hp.
While still not an SUV, the L-Series was a midsize sedan — a good step up from the S-Series. But while the S-Series was an original in-house design by Saturn engineers, the L-Series was little more than a badge-engineered Opel Vectra.
When did the 1997 Saturn’s series come out?
No accident or damage reported to CARFAX. Purchased on 12/15/97 and owned in NV until 06/02/21. Driven an estimated 3,430 miles/year. No service history reported on this vehicle. No accident or damage reported to CARFAX. 1st owner purchased on 04/18/96 and owned in SC until 11/09/20 •
In 1993, a wagon was added to the S-Series range, as well as a version of the coupe with the less powerful single overhead cam engine. This engine’s output was increased to 100 hp in 1995, which was also when the S-Series interior was given a significant makeover.
The SL2 featured an upgraded, dual-overhead-cam version of the same four-cylinder engine. It generated a relatively robust 124 horsepower at 5,600 rpm and 122 foot-pounds of torque at 4,800 rpm.
Where is the camshaft located on a Saturn I4 engine?
The SOHC and DOHC engines used different timing chain sets. The SOHC (LK0/L24) cylinder head had 8 valves and was made of lost foam cast aluminum. The camshaft was located in the center of the cylinder head and driven by a chain off the front crankshaft sprocket.
What kind of engine does a Saturn’s have?
The powerplant used in Saturn S-series automobiles was a straight-4 aluminum piston engine produced by Saturn, a subsidiary of General Motors. The engine was only used in the Saturn S-series line of vehicles (SL, SC, SW) from 1991 through 2002. It was available in chain-driven SOHC or DOHC variants. This was an…
What was the compression ratio of the Saturn I4?
The cylinder head was also redesigned to keep the compression ratio at 8.8:1 even with the flat top pistons and now featured provisions for an air injection reaction system. This engine was used from 1995 to 2002. The SOHC engine was available on the base model S-series vehicles (SC1, SL, SL1, SW, SW1)
Horsepower improved to 100 at 5,000 rpm, and torque was up to 114 pound-feet at 2,400 rpm. For those looking for more torque, there is the Saturn SL2. The SL2 is a trim level above the SL1 and is equipped with a more powerful 1.9 L I4 engine. The SL2’s engine has a dual overhead camshaft, 16 valves and a compression ratio of 9.5 to 1.
Which is more powerful the SL1 or the SL2?
The SL2 is a trim level above the SL1 and is equipped with a more powerful 1.9 L I4 engine. The SL2’s engine has a dual overhead camshaft, 16 valves and a compression ratio of 9.5 to 1. The design creates 124 horsepower at 5,600 rpm and 122 pound-feet of torque at 4,800 rpm.
When did the Saturn’s series come out?
The S-Series is a line of vehicles offered by Saturn from the early 1990’s through the early 2000’s. The S-Series’ are available as a sedan, coupe and wagon. Sedan models are known as the Saturn SL.
Horsepower improved to 100 at 5,000 rpm, and torque was up to 114 pound-feet at 2,400 rpm. For those looking for more torque, there is the Saturn SL2. The SL2 is a trim level above the SL1 and is equipped with a more powerful 1.9 L I4 engine. The SL2’s engine has a dual overhead camshaft, 16 valves and a compression ratio of 9.5 to 1.
When did the Saturn I4 engine come out?
This engine was used from 1995 to 2002. The SOHC engine was available on the base model S-series vehicles (SC1, SL, SL1, SW, SW1) 1992 through 1998 L24 cylinder heads developed issues with cracks developing in the fifth camshaft journal, located closest to #4 cylinder.