How much does it cost to replace a belt pulley?
The Best in Auto Repair The average cost for drive belt idler pulley replacement is between $133 and $153. Labor costs are estimated between $61 and $77 while parts are priced between $72 and $76. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
What belt goes on crankshaft pulley?
A belt known as the serpentine belt is attached to the crank pulley and moves through a large portion of the vehicle’s engine. This belt causes other moving pieces to run and provides power to auxiliary parts of the car when they are needed.
Can a bad pulley break a belt?
If the drive belt tensioner pulley has any sort of issue it can cause unusual and accelerated wear on the belt. A bad pulley can cause fraying on the edges of the belt, and in severe cases can even cause it to break.
Can a bad pulley cause loss of power?
Technically speaking, yes, an idler pulley will result in a slight power loss.
What can I do about a bad crankshaft pulley?
Remove crankshaft pulley bolt (usually using high torque impact wrench and pulley holder) The labor cost and price of a crankshaft pulley/harmonic balancer part may vary, depend on make, model and year of the car. If you decided to buy aftermarket product for harmonic balancer, I recommended you to buy Dorman harmonic balancer.
How much does it cost to replace a crankshaft pulley?
Replacement Cost. The cost to replace a bad crankshaft pulley is anywhere from $350 to $400. The cost of labor is around $150 to $180 and the cost of parts is around $200 to $220. It is not the most expensive replacement job, but it is not too cheap either.
How is the crankshaft pulley connected to the engine?
There is one mechanical system called a crankshaft pulley which helps distribute this engine power to other systems. The crankshaft pulley is connected to the crankshaft, which is a device that transforms the pistons’ linear motion into rotational motion.
What’s the best way to replace a drive belt?
Hold the belt close to the last pulley with one hand, then use the other hand to rotate the tensioner with the appropriate tool. Use your hand to slip the belt onto the final accessory pulley.