How much does a new four wheeler key cost?
The procedure normally would cost around 30$ for a single key, but then again prices can always vary.
How can I get a new Honda ignition key?
Here is how easy it is to get a key for your Honda! The code on the key, matches the code on the ignition switch. You just have to remove the switch and you’re home free! They’ll cut a new key for you! Sure enough, On the side of the Ignition switch is “7HKC17”. . .
Where are the keys on a Honda ATV?
I had absolutely no problem getting replacement precut keys for my switch on my 98 300 FOURTRAX without replacing the ignition switch. Simply pop the switch out and you will see a series of 4 letters and 2 numbers stamped on it. The fourth letter will always be a, b, or c. Mine was TJCA69.
How much is the ignition switch on a Honda ATV?
Your right about the ignition switch, $30 for a switch and two keys or $25 for one key.
What’s the fourth letter on a Honda Key?
The fourth letter will always be a, b, or c. Mine was TJCA69. The key code was A69. Called my local locksmith and they verified the key code to Honda and presto! 2 new keys. I only had 1 key OEM when I got my Foreman. I called the Honda dealer.
Here is how easy it is to get a key for your Honda! The code on the key, matches the code on the ignition switch. You just have to remove the switch and you’re home free! They’ll cut a new key for you! Sure enough, On the side of the Ignition switch is “7HKC17”. . .
Your right about the ignition switch, $30 for a switch and two keys or $25 for one key.
I had absolutely no problem getting replacement precut keys for my switch on my 98 300 FOURTRAX without replacing the ignition switch. Simply pop the switch out and you will see a series of 4 letters and 2 numbers stamped on it. The fourth letter will always be a, b, or c. Mine was TJCA69.
Is it possible to duplicate a Honda trx200?
OR, if you are careful with a file, you can duplicate your own key with this OEM blank: NEW GENUINE OEM HONDA KEY BLANK TRX200 TRX 200 250 TRX250 TE TM 300 TRX300 ATV I’ve done the blank key , set up with clamping them together with vise-grips, then using my dremel with a cut-off wheel to cut the grooves, works pretty good.