How much are Infiniti brakes?
Brake pads for a INFINITI can value anywhere between $150 per axle and $450 per axle depending on the type of brake pad desired. INFINITI Brake rotor replacement can value anywhere between $300 – $750 for all four rotors to be replaced.
How to install Infiniti G37 sport brake kit?
Use the Akebono Brake Template to check BEFORE installing the brake kit. Parts needed: Parts were ordered as a kit via TunerzStore.com and included Akebono front and rear calipers, Project mu front pads, Hawk rear pads, front and rear StopTech slotted rotors, front caliper mounting bracket with bolts, retainer clips.
When to bleed the brakes on an Infiniti G37?
When bleeding the brakes we performed 3 complete passes of the calipers to ensure they were completely bled. Always start with the caliper furthest from the Master Cylinder and work your way to the closest in this order: Rear passenger, Rear drivers, Front passenger, Front drivers.
How to remove the caliper on a Infiniti G37?
To fully remove the caliper use a 10mm brake line wrench and remove the line. Once the caliper is completely disconnected it can be removed and set to the side.
Where are the pad pins on a Infiniti G37?
The pad pins go in one way with the head (has indentions for a phillips head screwdriver) on the inside of the caliper. Slide the pin under the outer clips of the Cross Spring as shown via the red arrows, and over the center clip as shown via the orange arrow. It should slide in relatively easily. Do both pins the same way.
Use the Akebono Brake Template to check BEFORE installing the brake kit. Parts needed: Parts were ordered as a kit via TunerzStore.com and included Akebono front and rear calipers, Project mu front pads, Hawk rear pads, front and rear StopTech slotted rotors, front caliper mounting bracket with bolts, retainer clips.
When bleeding the brakes we performed 3 complete passes of the calipers to ensure they were completely bled. Always start with the caliper furthest from the Master Cylinder and work your way to the closest in this order: Rear passenger, Rear drivers, Front passenger, Front drivers.
To fully remove the caliper use a 10mm brake line wrench and remove the line. Once the caliper is completely disconnected it can be removed and set to the side.
The pad pins go in one way with the head (has indentions for a phillips head screwdriver) on the inside of the caliper. Slide the pin under the outer clips of the Cross Spring as shown via the red arrows, and over the center clip as shown via the orange arrow. It should slide in relatively easily. Do both pins the same way.