How many wires does an antilock brake sensor have?
Some of these sensors have three wires while others have only two. On the three-wire sensors, one wire is for power, one for ground and one for the return signal. On the two-wire sensors, one is the power and the other is ground. The return signal travels back to the module over the power supply wire.
What was the problem with my jwestley traction control?
For jwestley , the problem came from the both rear wheel sensors. “Service Stabiltrak, ABS, Traction Control lights came on. Dealer replaced a rear wheel speed sensor. Lights went off for about 500 miles, came on again. They then replaced the ABS module and the Throttle Position Sensor. Lights when off for about 2,000 miles.
Can you cut the wire on a door lock?
If you find that your wire colors do not match you can cut either one of the smaller gauge wires. There are four wires on the door lock actuator, two to power the actuator mechanism, and two to signal the door lock controller the state of the door lock. Do not cut the heavier gauge wires.
Why does my car door lock not work?
Over last few years my door locks have stopped working with the remote control and more recently several locks have stopped working when using the drivers door controls to lock the vehicle. I’m thinking there might be a relay or fuse issue but I don’t have a wiring diagram.
Can a rear driver’s side door lock work?
Exact fit and my rear driver’s side door lock is working again. Worked worked perfect for my 2008 RAM 1500. Only difficult part, at least for me, was getting the rubber wire loom seal seated back in the door.
When to disconnect the EBCM harness connector?
The reading should be the same speed on all sensors when driving in a straight line at a speed greater than 20 km/h (13 mph). It is recommended that Component Testing is performed before Circuit Testing when diagnosing wheel speed sensors. Ignition OFF, disconnect the harness connector at the EBCM.
Is there a replacement for a door harness?
Direct replacement – this door wiring harness is designed to match the fit, function and appearance of the original harness on specified vehicles Ideal solution – this harness is a reliable replacement for an original harness that is missing, failed or damaged due to corrosion