How many horsepower does a Twin Cam 96 have?
2007 Twin Cam 96 on a Road Glide, but all touring should be the same. I started off with a Fuel Moto map, which gave me 69 HP and 84 Torque. I ended up with 76 HP and 90 Lbs/Ft of Torque with this map. This map is an advanced map, where each cylinder is tuned separately.
How much torque does a power commander have?
The Power Commander map is attached. This map is an advanced map, where each cylinder is tuned separately. 2007 Twin Cam 96 on a Road Glide, but all touring should be the same. I started off with a Fuel Moto map, which gave me 69 HP and 84 Torque. I ended up with 76 HP and 90 Lbs/Ft of Torque with this map.
What’s the best cam upgrade for a 96ci?
Jamie tested a TC96 with 255’s and 2-into-1 recently and said that 2500-3500 TQ was lower than a stock engine with his custom baffles. This is not acceptable to me, as if I do a cam upgrade I will want TQ to increase in that important range, which is where I ride most, not decrease.
How much horsepower does a Dynojet power commander have?
Setup & tuned on Dynojet, O2 sensor eliminators installed, Rev Xtend enabled. Went from 56HP to 70hp & 76 lb Torque. High heat, surging and pinging now gone. … Did you find the recommended reading relevant to this discussion?
2007 Twin Cam 96 on a Road Glide, but all touring should be the same. I started off with a Fuel Moto map, which gave me 69 HP and 84 Torque. I ended up with 76 HP and 90 Lbs/Ft of Torque with this map. This map is an advanced map, where each cylinder is tuned separately.
The Power Commander map is attached. This map is an advanced map, where each cylinder is tuned separately. 2007 Twin Cam 96 on a Road Glide, but all touring should be the same. I started off with a Fuel Moto map, which gave me 69 HP and 84 Torque. I ended up with 76 HP and 90 Lbs/Ft of Torque with this map.
Setup & tuned on Dynojet, O2 sensor eliminators installed, Rev Xtend enabled. Went from 56HP to 70hp & 76 lb Torque. High heat, surging and pinging now gone. … Did you find the recommended reading relevant to this discussion?
How to make custom maps for power commander?
If you have questions, make a note of the poster’s name and ask the question in a new thread or the one already open for discussion. I had my ’06 Street Glide Dyno-tuned and had a custom map made.