How long is the drive shaft on a Chevy?
Now my driveshaft looks to be about 3 inches too long.Anyone have a driveshaft length on a 3 speed manual car or a dimension of the total length of a bell housing and 3 spd manual trans? The three speed manual transmission and bell housing together are the same length as the powerglide transmission.
Can You Grease a custom Chevy drive shaft?
All drive shafts are (greaseable unless otherwise requested). All drive shafts are built to a working length you provide us and the strength and u-joint requirements you need. There are no returns on custom drive shafts. However, we can credit toward another upgrade.
Where can I buy a custom drive shaft?
Drive Shaft Superstore makes custom-built drive shafts for any vehicle in our own machine shop. Our driveline solutions are of the finest quality and backed by our warranty. For all 4X4s and lowriders
How much does a Chevy slip drive shaft cost?
REAR CHEVY AND GMC DRIVE SHAFTS Blazer or GMC Slip with CV Drive Shaft You get the complete and precision balanced drive shaft Blazer or GMC Slip with CV Drive Shaft Standard Angle 1310 1/2 ton — $275 For 6 inch lifts
Where can I buy a custom Chevy drive shaft?
CUSTOM CHEVY DRIVE SHAFTS Drive Shaft Superstore makes custom-built drive shafts for any vehicle in our own machine shop. Our driveline solutions are of the finest quality and backed by our warranty. For all 4X4s and lowriders
What kind of driveshaft does a 1958 Chevy truck have?
The 1958 to 1964 Chevrolet cars and 1960-1972 Chevy C-10 half ton trucks have a frame structure that requires a 2 piece driveshaft design. This small diameter original equipment 2 piece driveshaft has never been associated with strength and reliability.
What’s the length of a Chevy Chevy driveshaft?
Thanks….he claims to have used the original driveshaft to the car and the car was originally a 3 spd manual transmission car. So if its the same as a PG…he used something else….because the driveshaft in his car now is the right length with the 700 installed.
What kind of driveshafts do Denny’s use?
Denny’s Driveshafts and Driveline parts for 1958 to 1964 Chevrolet cars 60-72 Trucks including Transmission slip yokes, pinion yokes, center support bearings, universal joints and hardware. The 1958 to 1964 Chevrolet cars and 1960-1972 Chevy C-10 half ton trucks have a frame structure that requires a 2 piece driveshaft design.