How long does it take to change a passenger airbag?
The time to replace the front-passenger airbag inflator is approximately two hours. However, it may be necessary to leave your vehicle for an extended period of time on the day of your appointment to allow your retailer flexibility in scheduling.
How can I Turn Off the SRS light?
This was a mistake because you cannot disconnect the wire harness from the column to the airbag to check for faulty wiring. You can unplug the wire from the airbag, by carefully pulling the plug. You need an allen wrench to remove the two screws on the back of the steering wheel to remove the front cover.
How do you remove an SRS airbag warning light?
Hold the center section of the wheel in place — where your airbag is located — and locate the screws. Unscrew them. Step 3: Once the screws have been unscrewed, pull the airbag towards you and remove the connectors. Use a pick to slide the yellow clips out in order to remove the connector. You can now remove the airbag.
Where is the SRS computer in a car?
First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat.
How much does it cost to repair a SRS light?
He said it was just the wiring harness that attaches to the sensor that costs about $20 to repair. But with labor, parts and reset it costed me almost $200. With Transmission flush (almost $500), free car wash, and SRS job, with a 15% off coupon, I paid about $670. Not bad.
Where is the reset SRS light on a Mercedes Benz?
Reset SRS/ Airbag light. 1. Locate the fuse panel cover and remove it. This is located on the lower left side of the control panel on the driver’s side of the car.
What should I do if my SRS light is on?
If your SRS/airbag light has been on for a long period of time, it needs to be taken care of right away. Here are some things you can do to fix it: Take your car to a mechanic: Take your vehicle into your local service shop or dealership service center to be seen by a certified mechanic.
What does SRS stand for in a car?
Your vehicle’s SRS is considered a passive restraint system. This means that you don’t have to do anything to activate it. It does it all on its own. Your SRS automatically detects things such as braking, deceleration, impact location, and if there’s a passenger in the front seat.
How to read and reset SRS / airbag light?
Battery dying. How to read and reset SRS/ Airbag light? Very often the SRS/Airbag light goes on mainly because of a dying battery. But, if the light is on, it will stay on when you install a new battery, until you manually reset it. That is, 2 steps to solve SRS/Airbag light on. Reset SRS/ Airbag light. 1. Locate the fuse panel cover and remove it.