How is the dis used to troubleshoot a fault?
The DIS provides Fault Symptom troubleshooting procedures with ac- cess to Fault codes, Status Requests, Component Activation, Special Service functions, etc. This section provides information regarding how the control modules communicate diagnostic informa- tion and/or fault recognition to the DIS and with each other via CAN communication.
What should I do if my power window is not working?
Use a fused jumper wire to bypass the switch and route power directly to the motor. If the window now moves, the problem is a bad switch. Replace the switch. If the motor does nothing, the problem is a bad motor. Replace the power window motor.
How do you pop out a power window door switch?
Many power window door switches simply pry out of their fixtures in the door panel. The trick is to pop out the switch without scratching or damaging the door panel. Use a flat, dull butter knife to slip under one edge of the switch, then gently pry up to loosen the switch.
What do the codes mean on Ford OBD?
The codes are defined as to what system is affected. When possible we give the more descriptive name of the component and the more commonly known OBD II component name. This information combined with proper testing procedures, specifications, and tools like a digital multimeter can help you fix the vehicle right the first time.
Why is the no co fault code not set?
This is because the No Co fault code is set when the fridge does not cool after turning on, the ARP detects this situation and usually intervenes before the No Co fault code can be set. If you do have the No Co turn on, this can be due to the temperature sensor (thermistor) in the fridge not sending a signal to the Norcold controller.
How to get the oak electric fault code?
1. Press the off button 2. Press ESC 3. [System Date/Time Batterty Sub Menus]is displayed 4. Press the up button until [sub menus] is blinking 5. Press ENTER 6. [History Maint Edit Dealer]is displayed 7. Press the up button until [Edit] is blinking 8. Press ENTER 9. Press the UP button until [Exercise Time]is displayed 10. Press ENTER 11.
What to do when your generator goes into fault mode?
1. The status lights on the generator will be green/yellow -proceed with maint reset. 2. If the customer sees red/yellow maintenance is needed and there is a fault. At some point the generator went into fault mode. A service call will be required. 3. Press off button … the screen will need to say [Switched to off] to proceed 4.
Where is the fault code stored on a refrigerator?
This fault code occurrence is then stored in the controls. If the refrigerator completes a full cooling cycle after the user turns it back on, this fault code occurrence will be cleared from the controls.