How is the battery on a Harley Davidson charged?
Tech review of the Harley Davidson charging system. Here’s an easy way to make sure your battery is charging. Everyone is at your house and ready to ride. You saddle up and CLICK, your Harley-Davidson does not start. Bob and Mark review an easy way to check your battery and make sure it’s staying charged.
What should the voltage be on a Harley Davidson Charger?
Generally speaking, 14.6 volts is a hard set regulation point on most 12 volt systems such as a Harley. Basically, this does not allow the regulator to send voltage to the battery any higher than 14.6 volts. If the stator fails, your battery will no longer be charging when you’re riding your motorcycle.
Where can I test my Harley Davidson battery?
Most places like Auto Zone, Advance Auto, and Pep Boys will charge and test motorcycle batteries for free. Standing battery Voltage should be 12.5-13.2 DCV. 2. Charging System Voltage Test Start motorcycle, measure DC Volts across the battery terminals (you should have a reading of approximately 13.2-15 DC Volts).
What happens if you have a bad voltage regulator on a Harley?
If there is anything wrong with the voltage regulator of your precious Harley, you will notice some unusual behaviors from the bike as follows – As I mentioned earlier, a bad regulator cannot control the voltage, which overcharges the battery. When the battery gets overcharged regularly, it causes the gas to escape from it.
Why does my Harley Davidson battery not charge?
Checked for shorts or opens on stator. Checks ok. Must be the regulator. Replaced the regulator. Same readings, battery still not charging. Checked the stator output again. Still appears to be working. Spoke to Bubbie by phone and he told me that Hoople might have some suggestions.
Is there a charger for my Harley Davidson?
If you are experiencing battery or charging issues with your Harley Davidson, do not run out and purchase a complete charging system without attempting to perform some basic testing first. It is our intention to explain testing procedures in more basic terms.
What should the charging voltage be on a Harley stator?
You can use 13 as a good all around battery voltage. That is a good healthy battery staying charged just above 12 volts. Example only: Let’s say the stator is rated for 10 amps x 13-volt battery: 10 x 13=130 watt charging system. So you have a 130-watt charging system in this example.
What kind of battery does a Harley Davidson have?
Everyone is at your house and ready to ride. You saddle up and CLICK, your Harley-Davidson does not start. Bob and Mark review an easy way to check your battery and make sure it’s staying charged. Click here to cancel reply. I have a 02 Harley Buell Blast 500 and I hooked up battery backwards and my wires smoked up white.