How fast does 50hp go?
With the new Honda 50 hp four stroke I find it will plane at about 17 or 18 mph. Top speed is 30 mph.
What’s the speed of a 50 hp Tohatsu?
My Tohatsu 50 will cruise along happily at 29 mph while turning 4500 rpm and burning 3-ish gph. With the stock prop no less. That’s hard to beat. When building my boat the Tohasu 50 and zuke 60 were within a couple hundred dollars of each other but the difference was in top end performance numbers. Somewhere in the neighborhood of 3-4 mph.
How can I get the top speed out of my outboard motor?
In some areas, however, having a motor overpowered from it’s original output is illegal. Change the propeller on the outboard. If you are looking to get the top speed out of your motor, select a propeller that has a higher pitch. This will slow the acceleration of the motor but the overall top speed will increase.
Can you put 60 hp on a 40hp boat?
Putting 60 HP carbs on the 40 or 50 HP will do nothing. The block on 60 HP motor has additonal port milling done to improve the mass air flow even better. Basicly, the three motors all use the same inductiion manifold and reeds. Linkages are the same unless you have a manual model. You willuse the old linkages on the new carbs.
How to increase the horsepower of an outboard motor?
A jack plate is one way to increase horsepower on an outboard motor. Gary Ballough is a 14-time world champion and 13-time national champion in offshore racing. Eric Colby 6. Get Advice from Other Boaters with Your Same Engine
In some areas, however, having a motor overpowered from it’s original output is illegal. Change the propeller on the outboard. If you are looking to get the top speed out of your motor, select a propeller that has a higher pitch. This will slow the acceleration of the motor but the overall top speed will increase.
What can I do with a Tohatsu 40hp outboard engine?
Can also be fitted with a Multifunction Tiller Handle to replace the remote control box if tiller control with electric start and power trim is preferred. EPTL and EPTS models are supplied with a side mount remote control box, tachometer and trim meter as standard (Pre-Rigging Kit).
A jack plate is one way to increase horsepower on an outboard motor. Gary Ballough is a 14-time world champion and 13-time national champion in offshore racing. Eric Colby 6. Get Advice from Other Boaters with Your Same Engine
Putting 60 HP carbs on the 40 or 50 HP will do nothing. The block on 60 HP motor has additonal port milling done to improve the mass air flow even better. Basicly, the three motors all use the same inductiion manifold and reeds. Linkages are the same unless you have a manual model. You willuse the old linkages on the new carbs.